Al-SiC/Al<sub>4</sub>C<sub>3</sub>中间合金制备及其对AZ63合金晶粒的细化

刘文成; 张耀先; 刘相法

doi:10.15980/j.tzzz.2014.06.027

轻有色合金 | 浏览量 : 0 下载量: 128 CSCD: 0

导出
分享
收藏
专辑

Al-SiC/Al₄C₃中间合金制备及其对AZ63合金晶粒的细化
Preparation of Al-SiC/Al₄C₃ Master Alloy and its Refinement on Grain of AZ63 Alloy
2014年34卷第6期页码：650-652
纸质出版日期： 2014 ，
DOI： 10.15980/j.tzzz.2014.06.027

扫描看全文

[1]刘文成,张耀先,刘相法.Al-SiC/Al_4C_3中间合金制备及其对AZ63合金晶粒的细化[J].特种铸造及有色合金,2014,34(06):650-652.

Liu Wencheng, Zhang Yaoxian, Liu Xiangfa. Preparation of Al-SiC/Al₄C₃ Master Alloy and its Refinement on Grain of AZ63 Alloy[J]. Special Casting & Nonferrous Alloys, 2014,34(6):650-652.
[1]刘文成,张耀先,刘相法.Al-SiC/Al_4C_3中间合金制备及其对AZ63合金晶粒的细化[J].特种铸造及有色合金,2014,34(06):650-652. DOI： 10.15980/j.tzzz.2014.06.027.

Liu Wencheng, Zhang Yaoxian, Liu Xiangfa. Preparation of Al-SiC/Al₄C₃ Master Alloy and its Refinement on Grain of AZ63 Alloy[J]. Special Casting & Nonferrous Alloys, 2014,34(6):650-652. DOI： 10.15980/j.tzzz.2014.06.027.

摘要

利用液相烧结法制备了一种Al-10SiC/Al4C3中间合金

并将其用于细化AZ63合金。X射线衍射分析结果表明

Al-10SiC/Al4C3中间合金的相组成除α-Al外

主要为Al4C3相、Si相以及未反应的SiC相。在750℃下加入0.5%的Al-10SiC/Al4C3中间合金

可以使AZ63合金的晶粒尺寸从450μm左右细化到150μm左右。当Al-10SiC/Al4C3中间合金加入量达到0.5%后

AZ63合金的晶粒尺寸不再随中间合金加入量的增加而继续减小。

Abstract

Al-10SiC/Al4C3master alloy grain refiner was prepared for the grain refinement of AZ63alloy through liquid sintering process.X-ray diffraction spectrum shows that the Al-10SiC/Al4C3master alloy is composed of primary Al phase

A14C3

Si and SiC.With 0.5% Al-10SiC/Al4C3master alloy addition at 750℃

the grain size of AZ63 magnesium alloy can be decreased from approximately 450μm to150μm.However

with Al-10SiC/Al4C3 master alloy addition more than 0.5%

refinement effects of grain size in the AZ63alloy can be ignored.