氩弧熔覆原位自生TiC/TiN增强镍基复合涂层分析

王永东; 于小永; 刘兴

doi:10.15980/j.tzzz.2014.04.030

复合材料 | 浏览量 : 0 下载量: 126 CSCD: 2

导出
分享
收藏
专辑

氩弧熔覆原位自生TiC/TiN增强镍基复合涂层分析
Analysis of In-situ TiC/TiN Reinforced Ni-based Composite Coating by Argon Arc Cladding
2014年34卷第4期页码：420-422
纸质出版日期： 2014 ，
DOI： 10.15980/j.tzzz.2014.04.030

扫描看全文

[1]王永东,于小永,刘兴.氩弧熔覆原位自生TiC/TiN增强镍基复合涂层分析[J].特种铸造及有色合金,2014,34(04):420-422.

Wang Yongdong, Yu Xiaoyong, Liu Xing. Analysis of In-situ TiC/TiN Reinforced Ni-based Composite Coating by Argon Arc Cladding[J]. Special Casting & Nonferrous Alloys, 2014,34(4):420-422.
[1]王永东,于小永,刘兴.氩弧熔覆原位自生TiC/TiN增强镍基复合涂层分析[J].特种铸造及有色合金,2014,34(04):420-422. DOI： 10.15980/j.tzzz.2014.04.030.

Wang Yongdong, Yu Xiaoyong, Liu Xing. Analysis of In-situ TiC/TiN Reinforced Ni-based Composite Coating by Argon Arc Cladding[J]. Special Casting & Nonferrous Alloys, 2014,34(4):420-422. DOI： 10.15980/j.tzzz.2014.04.030.

摘要

以Ti粉、C粉、TiN粉和Ni60A粉末为原料

利用氩弧熔覆技术在16Mn钢基材表面成功制备出Ni基增强相复合涂层

应用OM、SEM、XRD对复合涂层的显微组织和物相进行了分析。结果表明

复合涂层物相由TiC、TiN颗粒

γ-Ni奥氏体枝晶和枝晶间的Cr23C6共晶组织组成。涂层的硬度（HV0.2）达到900

较基体16Mn钢提高了3倍多;相对耐磨性较基体16Mn钢提高了8倍。

Abstract

Ni-based reinforced composite coating was prepared successfully on the surface of 16Mn steel with the pre-alloyed powder of Ti

TiN and Ni60Aby means of argon arc cladding technique.The microstructure and phase constituent were investigated using OM（optical microscope）、SEM（scanning electron microscopy）and XRD（X-ray diffraction）.The results show that the composite coating is composed of TiC、TiN

γ-Ni and M23C6particles.The microhardness can reach 900HV0.2

which is 3times higher than that of 16Mn steel.The relative wear resistance of coating is about 8times higher than that of 16Mn steel substrate.