挤压铸造斗齿缺陷的原因分析及其对策

郭洪钢; 邢书明; 鲍培伟

doi:10.15980/j.tzzz.2013.08.021

压力铸造 | 浏览量 : 0 下载量: 100 CSCD: 2

导出
分享
收藏
专辑

挤压铸造斗齿缺陷的原因分析及其对策
Origination of Defects in Bucket Teeth in Squeeze Casting and its Countermeasures
2013年33卷第8期页码：740-742
纸质出版日期： 2013 ，
DOI： 10.15980/j.tzzz.2013.08.021

扫描看全文

[1]郭洪钢,邢书明,鲍培伟.挤压铸造斗齿缺陷的原因分析及其对策[J].特种铸造及有色合金,2013,33(08):740-742.

Guo Honggang, Xing Shuming, Bao Peiwei. Origination of Defects in Bucket Teeth in Squeeze Casting and its Countermeasures[J]. Special Casting & Nonferrous Alloys, 2013,33(8):740-742.
[1]郭洪钢,邢书明,鲍培伟.挤压铸造斗齿缺陷的原因分析及其对策[J].特种铸造及有色合金,2013,33(08):740-742. DOI： 10.15980/j.tzzz.2013.08.021.

Guo Honggang, Xing Shuming, Bao Peiwei. Origination of Defects in Bucket Teeth in Squeeze Casting and its Countermeasures[J]. Special Casting & Nonferrous Alloys, 2013,33(8):740-742. DOI： 10.15980/j.tzzz.2013.08.021.

摘要

对采用挤压铸造方法生产斗齿类零件过程出现的缺陷及其防治措施进行了综合分析与讨论。结果表明

挤压铸造的工艺参数和模具结构设计对制件质量的影响至关重要。当模具预热温度在（250±10）℃

浇注温度控制为1620℃时

挤压铸造比压为100MPa

保压时间为17s

模具内浇道采用扇形结构

通过对合金液充型时的流量合理控制

可以避免缺陷的产生。

Abstract

Origination of defects in bucket teeth in squeeze casting and its countermeasures were approached.The experimental results show that it is very important of processing parameters and structure design in squeezing casting on quality of squeezing casting bucket teeth.With the preheating temperature of die of 250±10 ℃

the pouring temperature of 1 620 ℃ and the forming pressure of 100 MPa for 17 s

through reasonably controlling the flow velocity in the ingate with sector structure

the defects occurred in bucket teeth by squeeze casting can be eliminated effectively.