ZL201合金半固态铸造与挤压成形的显微组织

撒世勇; 石天宇; 王平

doi:10.15980/j.tzzz.2013.08.018

半固态加工 | 浏览量 : 0 下载量: 122 CSCD: 0

导出
分享
收藏
专辑

ZL201合金半固态铸造与挤压成形的显微组织
Microstructure of Semi-solid Casting and Extrusion Forming ZL201 Alloy
2013年33卷第8期页码：729-731
纸质出版日期： 2013 ，
DOI： 10.15980/j.tzzz.2013.08.018

扫描看全文

[1]撒世勇,石天宇,王平.ZL201合金半固态铸造与挤压成形的显微组织[J].特种铸造及有色合金,2013,33(08):729-731.

Sa Shiyong1, Shi Tianyu2, Wang Ping3. Microstructure of Semi-solid Casting and Extrusion Forming ZL201 Alloy[J]. Special Casting & Nonferrous Alloys, 2013,33(8):729-731.
[1]撒世勇,石天宇,王平.ZL201合金半固态铸造与挤压成形的显微组织[J].特种铸造及有色合金,2013,33(08):729-731. DOI： 10.15980/j.tzzz.2013.08.018.

Sa Shiyong1, Shi Tianyu2, Wang Ping3. Microstructure of Semi-solid Casting and Extrusion Forming ZL201 Alloy[J]. Special Casting & Nonferrous Alloys, 2013,33(8):729-731. DOI： 10.15980/j.tzzz.2013.08.018.

摘要

采用近液相线铸造法制备出ZL201合金半固态锭坯

并对其进行了触变挤压成形。利用金相显微镜观察了其组织变化

并与常规铸造ZL201合金的组织与挤压成形件的组织进行了对比分析。研究结果表明

半固态合金挤压后组织更细小均匀

消除了宏观偏析、晶内疏松等缺陷。主要原因是在挤压过程中晶粒的变形量、畸变区域很大

故在动态再结晶的过程中

半固态合金组织发生再结晶转变的体积分数大于常规铸造合金组织发生再结晶转变的体积分数。

Abstract

The semi-solid ZL201 alloy slurry prepared by near-liquidus casting was thixo-extruded

and microstructure of the thixo-extruded parts was observed and analyzed comparatively with those of conventional casting ZL201 alloy parts and squeezing casting parts.The results reveal that microstructure of thixo-extruded parts exhibit fine and uniform with absence of macro-segregation and grain porosities

which are beneficial for improving the mechanical properties of ZL201 alloy parts.During thixo-extruded process

there exist severe grain deformation and distortion zone

leading to recrystallization fraction in semi-solid alloy slurry during dynamic recrystalliztion process higher than that in conventional casting ones

which is responsible for the fine uniform distribution of grain size in thixo-extruded parts