基于Anycasting的齿圈座的铸造工艺优化

吴康平; 刘杰

doi:10.15980/j.tzzz.2013.08.016

计算机应用技术 | 浏览量 : 0 下载量: 112 CSCD: 1

导出
分享
收藏
专辑

基于Anycasting的齿圈座的铸造工艺优化
Processing Optimization for Gear Seat Based on Anycasting Software
2013年33卷第8期页码：719-722
纸质出版日期： 2013 ，
DOI： 10.15980/j.tzzz.2013.08.016

扫描看全文

[1]吴康平,刘杰.基于Anycasting的齿圈座的铸造工艺优化[J].特种铸造及有色合金,2013,33(08):719-722.

Wu Kangping, Liu Jie. Processing Optimization for Gear Seat Based on Anycasting Software[J]. Special Casting & Nonferrous Alloys, 2013,33(8):719-722.
[1]吴康平,刘杰.基于Anycasting的齿圈座的铸造工艺优化[J].特种铸造及有色合金,2013,33(08):719-722. DOI： 10.15980/j.tzzz.2013.08.016.

Wu Kangping, Liu Jie. Processing Optimization for Gear Seat Based on Anycasting Software[J]. Special Casting & Nonferrous Alloys, 2013,33(8):719-722. DOI： 10.15980/j.tzzz.2013.08.016.

摘要

运用AnyCasting对齿圈座铸件工艺方案进行模拟

结果表明铸件存在铸造缺陷。针对原工艺存在的不足

对工艺进行了优化

包括浇注系统和冒口的设计、冷铁的放置等。工艺优化后

铸件缺陷出现的概率大大降低

铸件工艺出品率得到提高。

Abstract

The casting process of gear seat was simulated by the AnyCasting software.The results show that the casting defects exist in the gear seat ring.Aiming at the disadvantages of the initiall process

optimized measures were presented as follows:optimizing gating system and riser design

setting chills

etc.After optimization

the probability of defects was decreased greatly

and the technological yield was increased.