分级热处理对Zn-40Al-4Cu合金组织和性能的影响

汪兴娟; 江宇; 何顺荣; 王久林; 刘伟伟; 董雄英; 宣自军

doi:10.15980/j.tzzz.2013.06.029

重有色合金 | 浏览量 : 0 下载量: 82 CSCD: 2

导出
分享
收藏
专辑

分级热处理对Zn-40Al-4Cu合金组织和性能的影响
Influence of Step Solution Heat Treatment on Microstructure and Performance of Zn-40Al-4Cu Alloys
2013年33卷第6期页码：555-558
纸质出版日期： 2013 ，
DOI： 10.15980/j.tzzz.2013.06.029

扫描看全文

[1]汪兴娟,江宇,何顺荣,王久林,刘伟伟,董雄英,宣自军.分级热处理对Zn-40Al-4Cu合金组织和性能的影响[J].特种铸造及有色合金,2013,33(06):555-558.

Wang Xingjuan1, Jiang Yu1, He Shunrong1, et al. Influence of Step Solution Heat Treatment on Microstructure and Performance of Zn-40Al-4Cu Alloys[J]. Special Casting & Nonferrous Alloys, 2013,33(6):555-558.
[1]汪兴娟,江宇,何顺荣,王久林,刘伟伟,董雄英,宣自军.分级热处理对Zn-40Al-4Cu合金组织和性能的影响[J].特种铸造及有色合金,2013,33(06):555-558. DOI： 10.15980/j.tzzz.2013.06.029.

Wang Xingjuan1, Jiang Yu1, He Shunrong1, et al. Influence of Step Solution Heat Treatment on Microstructure and Performance of Zn-40Al-4Cu Alloys[J]. Special Casting & Nonferrous Alloys, 2013,33(6):555-558. DOI： 10.15980/j.tzzz.2013.06.029.

摘要

研究了分级热处理工艺对Zn-40Al-4Cu合金组织和耐磨性的影响。结果表明

分级热处理工艺能改善合金微观组织及成分均匀性

使α枝晶转变为块状

α+η共析体由片层状转变为颗粒状

ε相尺寸减小

形状变得圆整

大大增加了Zn-40Al-4Cu合金的硬度

减小摩擦因数

降低磨损量。

Abstract

Influences of the step solution heat treatment on microstructure and wear resistance of Zn-40Al-4Cu alloy were investigated. The results show that step solution treatment can improve the microstructure and homogeneous composition of Zn-40Al-4Cu alloy

where α dendrite is converted into block one

and α+η eutectoid structure is transformed from lamellar to well mixed particles. The size of ε phase is reduced with more round shape. In addition

step heat treatment can increase greatly the hardness of Zn-40Al-4Cu alloy and reduce the coefficient of friction and wear loss.