热处理对新型高铝青铜组织及性能的影响

严高闯; 戴安伦; 朱治愿; 刘景帅

doi:10.15980/j.tzzz.2013.06.028

重有色合金 | 浏览量 : 0 下载量: 192 CSCD: 3

导出
分享
收藏
专辑

热处理对新型高铝青铜组织及性能的影响
Effects of Heating Treatment on Microstructure and Mechanical Properties of Novel High Aluminum Bronzes Alloy
2013年33卷第6期页码：551-554
纸质出版日期： 2013 ，
DOI： 10.15980/j.tzzz.2013.06.028

扫描看全文

[1]严高闯,戴安伦,朱治愿,刘景帅.热处理对新型高铝青铜组织及性能的影响[J].特种铸造及有色合金,2013,33(06):551-554.

Yan Gaochuang1, Dai Anlun1, Zhu Zhiyuan1, et al. Effects of Heating Treatment on Microstructure and Mechanical Properties of Novel High Aluminum Bronzes Alloy[J]. Special Casting & Nonferrous Alloys, 2013,33(6):551-554.
[1]严高闯,戴安伦,朱治愿,刘景帅.热处理对新型高铝青铜组织及性能的影响[J].特种铸造及有色合金,2013,33(06):551-554. DOI： 10.15980/j.tzzz.2013.06.028.

Yan Gaochuang1, Dai Anlun1, Zhu Zhiyuan1, et al. Effects of Heating Treatment on Microstructure and Mechanical Properties of Novel High Aluminum Bronzes Alloy[J]. Special Casting & Nonferrous Alloys, 2013,33(6):551-554. DOI： 10.15980/j.tzzz.2013.06.028.

摘要

利用合金化方法制备了一种新型高铝青铜合金

通过XRD、扫描电镜、HRS-150洛氏硬度仪等研究了热处理对铸态新型高铝青铜合金组织和性能的影响

得出了合金的最佳固溶时效工艺参数。结果表明

试验铝青铜合金铸态下的显微组织由α、β’、γ2和k相组成

合金经过950℃×2h固溶（油淬）+550℃×4h时效（空冷）处理后

硬度（HRC）为42.6

抗拉强度为890MPa

伸长率为9.84%

表现出良好的综合力学性能。

Abstract

Effect of heating treatment on microstructure and mechanical properties of a novel high aluminum bronze which was prepared by alloying method were investigated by XRD （X-ray diffraction）

SEM （scanning electron microscope） and HRS-150 Rockwell hardness tester

and the optimized parameters for solution-aging treatment were presented. The results show that the as-cast microstructure of alloy is composed mainly of α

β ’

γ2 and k phases. The hardness

tensile strength and elongation of the alloy prepared reach 42.6HRC

890 MPa and 9.84%

respectively

after 950 ℃×2 h solution（quenching in oil）+550℃×4h aging（cooling in air）

exhibiting acceptable comprehensive mechanical properties.