Al-Ti-C中间合金对Mg-8Li-3Al合金组织和性能的影响

李明; 郝海; 张爱民; 宋迎德; 张兴国

doi:10.15980/j.tzzz.2013.01.018

轻有色合金 | 浏览量 : 0 下载量: 151 CSCD: 6

导出
分享
收藏
专辑

Al-Ti-C中间合金对Mg-8Li-3Al合金组织和性能的影响
Effects of Al-Ti-C Master Alloy on Microstructure and Mechanical Properties of Mg-8Li-3Al Alloy
2013年33卷第1期页码：81-84
纸质出版日期： 2013 ，
DOI： 10.15980/j.tzzz.2013.01.018

扫描看全文

[1]李明,郝海,张爱民,宋迎德,张兴国.Al-Ti-C中间合金对Mg-8Li-3Al合金组织和性能的影响[J].特种铸造及有色合金,2013,33(01):81-84.

Li Ming, Hao Hai, Zhang Aimin, et al. Effects of Al-Ti-C Master Alloy on Microstructure and Mechanical Properties of Mg-8Li-3Al Alloy[J]. Special Casting & Nonferrous Alloys, 2013,33(1):81-84.
[1]李明,郝海,张爱民,宋迎德,张兴国.Al-Ti-C中间合金对Mg-8Li-3Al合金组织和性能的影响[J].特种铸造及有色合金,2013,33(01):81-84. DOI： 10.15980/j.tzzz.2013.01.018.

Li Ming, Hao Hai, Zhang Aimin, et al. Effects of Al-Ti-C Master Alloy on Microstructure and Mechanical Properties of Mg-8Li-3Al Alloy[J]. Special Casting & Nonferrous Alloys, 2013,33(1):81-84. DOI： 10.15980/j.tzzz.2013.01.018.

摘要

通过液固反应制备了含TiC和Al4C3相的Al-Ti-C中间合金

并利用OM、XRD、SEM和EDS等研究了Al-Ti-C中间合金对Mg-8Li-3Al合金显微组织和力学性能的影响。结果表明

Al-Ti-C中间合金的最佳加入量为1.0%;加入量为1.0%时

粗大的α相树枝晶变成颗粒状

并且α相变得更加细小圆整

合金的抗拉强度和伸长率分别达到199.28MPa和14.60%。

Abstract

The Al-Ti-C master alloy containing TiC and Al4C3 was prepared by a liquid-solid reaction. The effects of the Al-Ti-C master alloy additions on the microstructure and mechanical properties of Mg-8Li-3Al alloy were investigated by means of OM （optical microscopy）

XRD（X-ray diffraction）

SEM（scanning electron microscopy） and EDS （energy dispersive spectrometer）. The results show that the optimal addition of Al-Ti-C master alloy into Mg-8Li-3Al alloy is 1.0%. The morphology of large α-phases dendrites is changed into particles

and the sizes of α-phases are reduced with spheroidization. Meanwhile

the tensile strength and the elongation of Mg-8Li-3Al alloy reach 199.28 MPa and 14.60%

respectively.