解决ETC节流阀体二次加工面轮廓度超差的方法

乔月忠; 赵炳华; 陈群英

doi:10.15980/j.tzzz.2012.12.020

压力铸造 | 浏览量 : 0 下载量: 37 CSCD: 1

导出
分享
收藏
专辑

解决ETC节流阀体二次加工面轮廓度超差的方法
Method to Solving Oversize of Planar Profile Tolerance of Secondary Machining for ETC Throttle Valve Body
2012年32卷第12期页码：1126-1128
纸质出版日期： 2012 ，
DOI： 10.15980/j.tzzz.2012.12.020

扫描看全文

[1]乔月忠,赵炳华,陈群英.解决ETC节流阀体二次加工面轮廓度超差的方法[J].特种铸造及有色合金,2012,32(12):1126-1128.

Qiao Yuezhong, Zhao Binghua, Chen Qunying. Method to Solving Oversize of Planar Profile Tolerance of Secondary Machining for ETC Throttle Valve Body[J]. Special Casting & Nonferrous Alloys, 2012,32(12):1126-1128.
[1]乔月忠,赵炳华,陈群英.解决ETC节流阀体二次加工面轮廓度超差的方法[J].特种铸造及有色合金,2012,32(12):1126-1128. DOI： 10.15980/j.tzzz.2012.12.020.

Qiao Yuezhong, Zhao Binghua, Chen Qunying. Method to Solving Oversize of Planar Profile Tolerance of Secondary Machining for ETC Throttle Valve Body[J]. Special Casting & Nonferrous Alloys, 2012,32(12):1126-1128. DOI： 10.15980/j.tzzz.2012.12.020.

摘要

通过认真分析

发现面轮廓度的测量方法和R基准面的加工方法不足是造成ETC节流阀体二次加工面轮廓度超差的主要原因。经过大量的数据验证

采取规范的面轮廓度的测量方法和R基准面的机加工为先粗加工

后精加工

分别完成

从而杜绝了面轮廓度超差的产品产生。

Abstract

The reasons of causing oversize of planar profile tolerance of secondary machining for ETC throttle valve body was analyzed carefully

which was attributed to the problems in measuring methods of planar profile tolerance and cutting methods of Rbase level.Based on amounts of data experiments

through using methods of standardized planar profile tolerance and roughing and finishing for Rbase level

the defects of oversize of planar profile tolerance can be totally eliminated.

关键词

节流阀体二次加工面轮廓度超差

Keywords

Throttle Valve BodySecondary CuttingPlanar Profile ToleranceOversize

references

文章被引用时，请邮件提醒。

提交

提高压铸变速箱中间板二次加工工程能力的方法