ZTA/YL302复合材料的组织与力学性能

谭俊; 郑开宏; 邓运来; 王娟

doi:10.15980/j.tzzz.2012.11.008

复合材料 | 浏览量 : 0 下载量: 103 CSCD: 1

导出
分享
收藏
专辑

ZTA/YL302复合材料的组织与力学性能
Microstructure and Mechanical Properties of ZTA/YL302 Composites
2012年32卷第11期页码：1011-1014
纸质出版日期： 2012 ，
DOI： 10.15980/j.tzzz.2012.11.008

扫描看全文

[1]谭俊,郑开宏,邓运来,王娟.ZTA/YL302复合材料的组织与力学性能[J].特种铸造及有色合金,2012,32(11):1011-1014.

Tan Jun1, Zheng Kaihong1, Deng Yunlai1, et al. Microstructure and Mechanical Properties of ZTA/YL302 Composites[J]. Special Casting & Nonferrous Alloys, 2012,32(11):1011-1014.
[1]谭俊,郑开宏,邓运来,王娟.ZTA/YL302复合材料的组织与力学性能[J].特种铸造及有色合金,2012,32(11):1011-1014. DOI： 10.15980/j.tzzz.2012.11.008.

Tan Jun1, Zheng Kaihong1, Deng Yunlai1, et al. Microstructure and Mechanical Properties of ZTA/YL302 Composites[J]. Special Casting & Nonferrous Alloys, 2012,32(11):1011-1014. DOI： 10.15980/j.tzzz.2012.11.008.

摘要

对挤压铸渗法制备的ZTA/YL302复合材料进行冲击和磨粒磨损试验。利用光学显微镜和电子显微镜观察复合材料试验前后的表面形貌。结果表明

ZTA预制件的孔隙率为40%～55%

渗透的基体为YL302合金。相比YL302合金

复合材料的耐磨性能显著提高

但是冲击韧度有所下降;复合材料在铸态（F）下的冲击韧度比T6热处理后的冲击韧度略高

铸态下的耐磨性能比T6热处理后的高。

Abstract

The impact and abrasive wear experiments of ZTA/YL302 composites prepared by squeeze infiltration were conducted. The surface morphology of the composites before and after experiment was observed by optical microscopy （OM）and scanning electron microscopy （SEM）. The results indicate that the porosity percentage of ZTA preform reaches 40%

5% with the matrix alloy YL302. Compared with that of the YL302 alloy

the wear resistance of the composite prepared is increased by three times

however

the impact toughness is decreased slightly. The impact toughness of the composites in as-cast state（F） is slightly higher than that in T6 state

and the wear resistance is better than that in T6 treated one.