ZL205A合金壳体铸件低压铸造工艺研究

吴士平; 王晔; 吴光然; 张建兵; 肖文峰

doi:10.15980/j.tzzz.2012.09.019

压力铸造 | 浏览量 : 0 下载量: 426 CSCD: 11

导出
分享
收藏
专辑

ZL205A合金壳体铸件低压铸造工艺研究
Production of ZL205A Alloy Shell Castings by Low Pressure Casting
2012年32卷第9期页码：811-813
纸质出版日期： 2012 ，
DOI： 10.15980/j.tzzz.2012.09.019

扫描看全文

[1]吴士平,王晔,吴光然,张建兵,肖文峰.ZL205A合金壳体铸件低压铸造工艺研究[J].特种铸造及有色合金,2012,32(09):811-813.

Wu Shiping1, Wang Ye1, Wu Guangran2, et al. Production of ZL205A Alloy Shell Castings by Low Pressure Casting[J]. Special Casting & Nonferrous Alloys, 2012,32(9):811-813.
[1]吴士平,王晔,吴光然,张建兵,肖文峰.ZL205A合金壳体铸件低压铸造工艺研究[J].特种铸造及有色合金,2012,32(09):811-813. DOI： 10.15980/j.tzzz.2012.09.019.

Wu Shiping1, Wang Ye1, Wu Guangran2, et al. Production of ZL205A Alloy Shell Castings by Low Pressure Casting[J]. Special Casting & Nonferrous Alloys, 2012,32(9):811-813. DOI： 10.15980/j.tzzz.2012.09.019.

摘要

以低压铸造成形ZL205A合金壳体件作为研究对象

采用数值模拟方法

研究了壳体铸件低压铸造过程温度场及缩孔、缩松缺陷随工艺方案的变化规律。结果表明

采用冷铁及冒口

缝隙式浇口由8个增加到10个

补缩距离由200mm减小到157mm

铸件的温度场分布合理

铸件缺陷部位的缩松倾向明显减小

模拟结果与试验结果对比

表明采用冒口结合冷铁的工艺方案合理可行。

Abstract

The temperature field

shrinkage porosity（hole） in the ZL205A alloy shell castings during low pressure casting process were visualized through numerical simulation.The results show that the desirable temperature filed can be obtained and tendency of shrinkage porosity in the defect location of the shell can be reduced by using the chill and riser

adding the number of slit runners from eight to ten and decreasing the length of feeding distance from 200 mm to 157 mm.Comparison with the experimental results indicates that the scheme of chill combining with riser is reasonable and feasible.