离心激冷制备半固态铝合金

韩言言; 周全; 陈乐平

doi:10.15980/j.tzzz.2012.05.014

半固态加工 | 浏览量 : 0 下载量: 72 CSCD: 1

导出
分享
收藏
专辑

离心激冷制备半固态铝合金
Preparation of Semi-Solid Aluminum Alloy by Centrifugal and Chilling Casting
2012年32卷第5期页码：430-432
纸质出版日期： 2012 ，
DOI： 10.15980/j.tzzz.2012.05.014

扫描看全文

[1]韩言言,周全,陈乐平.离心激冷制备半固态铝合金[J].特种铸造及有色合金,2012,32(05):430-432.

Han Yanyan, Zhou Quan, Chen Leping. Preparation of Semi-Solid Aluminum Alloy by Centrifugal and Chilling Casting[J]. Special Casting & Nonferrous Alloys, 2012,32(5):430-432.
[1]韩言言,周全,陈乐平.离心激冷制备半固态铝合金[J].特种铸造及有色合金,2012,32(05):430-432. DOI： 10.15980/j.tzzz.2012.05.014.

Han Yanyan, Zhou Quan, Chen Leping. Preparation of Semi-Solid Aluminum Alloy by Centrifugal and Chilling Casting[J]. Special Casting & Nonferrous Alloys, 2012,32(5):430-432. DOI： 10.15980/j.tzzz.2012.05.014.

摘要

研究了离心激冷装置下半固态ZL203铝合金的制备

考察了不同的离心转速、外桶预热温度和浇注温度对合金初生相形态的影响规律。结果表明

采用离心激冷的方法可以制备出初生相为球状或细小颗粒状晶粒的半固态铝合金;随着离心转速提高

合金的初生相逐渐细化

其形态由等轴枝晶变成细小的球状或颗粒状晶粒;随着激冷桶预热温度和浇注温度降低

合金的初生相先细化

后有所粗化。

Abstract

Semi-solid ZL203 alloy billets were prepared by centrifugal and chilling device

and effects of different rotating speed

preheating temperature and pouring temperature on primary phase in the alloy were investigated.The results show that semi-solid aluminum alloy with spherical or granular primary grain can be prepared by centrifugal and chilling technology.Primary phase becomes finer with the increase of rotating speed

and its morphology is transformed from equiaxed dendrite into spherical or granular one.With the decrease of preheating temperature or pouring temperature

primary phase size is firstly decreased and then increased.