均匀化热处理参数对7085铸锭组织性能的影响

樊振中; 张东; 贺笃鹏; 王海龙; 周志宇; 张景亮; 陆政

doi:10.15980/j.tzzz.2022.10.001

本期推荐 | 浏览量 : 0 下载量: 67 CSCD: 0

PDF
导出
分享
收藏
专辑

均匀化热处理参数对7085铸锭组织性能的影响
Effects of Homogenizing Heat Treatment Parameters on Microstructure and Properties of 7085 Ingot
2022年42卷第10期页码：1189-1196
纸质出版日期： 2022 ，
DOI： 10.15980/j.tzzz.2022.10.001

扫描看全文

樊振中, 张东, 贺笃鹏, 等. 均匀化热处理参数对7085铸锭组织性能的影响[J]. 特种铸造及有色合金, 2022,42(10):1189-1196.

Fan Zhenzhong, Zhang Dong, He Dupeng, et al. Effects of Homogenizing Heat Treatment Parameters on Microstructure and Properties of 7085 Ingot[J]. Special Casting & Nonferrous Alloys, 2022,42(10):1189-1196.
樊振中, 张东, 贺笃鹏, 等. 均匀化热处理参数对7085铸锭组织性能的影响[J]. 特种铸造及有色合金, 2022,42(10):1189-1196. DOI： 10.15980/j.tzzz.2022.10.001.

Fan Zhenzhong, Zhang Dong, He Dupeng, et al. Effects of Homogenizing Heat Treatment Parameters on Microstructure and Properties of 7085 Ingot[J]. Special Casting & Nonferrous Alloys, 2022,42(10):1189-1196. DOI： 10.15980/j.tzzz.2022.10.001.

摘要

以7085大规格半连续铸锭为研究对象，对其进行了不同的均匀化热处理，研究了热处理温度与时间对7085铸锭组织与性能的影响，对比分析了单级与双级均匀化热处理后的材料性能。结果表明，7085大规格铸锭升温速率约为0.4℃/(min·mm)时，铸态枝晶组织与晶界区域低熔点T相经均匀化热处理后基本溶入初生α-Al基体内部，材料塑性与电导率得到明显改善。经(430±5)℃×8 h+(460±5)℃×24 h热处理后材料的平均抗拉强度、屈服强度、伸长率与电导率分别为352 MPa、264 MPa、13.3%与19.616 MS/m

断口表面以沿晶断裂为主。

Abstract

Effects of homogenizing heat treatment temperature and time on microstructure and properties of 7085 large semi-continuous ingot were investigated and compared with the different process systems. The results indicate that when the temperature-increment rate is about 0.4 ℃/（min·mm）

the low-melting T phase and as-cast dendrite structure are melted into the primary α-Al matrix after the homogenizing heat treatment process

leading to the obvious improvement of plasticity and electrical conductivity. The average tensile strength

yield strength

elongation and conductivity reach 352 MPa

264 MPa

13.3% and 19.616 MS/m

respectively

after heat treatment for（430±5） ℃×8 h+（460±5） ℃×24 h

where the facture surface is dominated by intercrystalline fracture.