Ti对Mg-Er-Ni合金组织和力学性能的影响

邱志文; 刘长灵; 周益环

doi:10.15980/j.tzzz.2022.08.020

研究·合金性能 | 浏览量 : 0 下载量: 51 CSCD: 0

PDF
导出
分享
收藏
专辑

Ti对Mg-Er-Ni合金组织和力学性能的影响
Effects of Ti on Microstructure and Mechanical Properties of Mg-Er-Ni Alloy
2022年42卷第8期页码：1020-1023
纸质出版日期： 2022 ，
DOI： 10.15980/j.tzzz.2022.08.020

扫描看全文

邱志文, 刘长灵, 周益环. Ti对Mg-Er-Ni合金组织和力学性能的影响[J]. 特种铸造及有色合金, 2022,42(8):1020-1023.

Qiu Zhiwen, Liu Changling, Zhou Yihuan. Effects of Ti on Microstructure and Mechanical Properties of Mg-Er-Ni Alloy[J]. Special Casting & Nonferrous Alloys, 2022,42(8):1020-1023.
邱志文, 刘长灵, 周益环. Ti对Mg-Er-Ni合金组织和力学性能的影响[J]. 特种铸造及有色合金, 2022,42(8):1020-1023. DOI： 10.15980/j.tzzz.2022.08.020.

Qiu Zhiwen, Liu Changling, Zhou Yihuan. Effects of Ti on Microstructure and Mechanical Properties of Mg-Er-Ni Alloy[J]. Special Casting & Nonferrous Alloys, 2022,42(8):1020-1023. DOI： 10.15980/j.tzzz.2022.08.020.

摘要

在LPSO结构增强Mg

97.75

1.5

0.75

合金中添加Ti

研究Ti含量对合金凝固组织和力学性能的影响。结果表明，添加Ti能够显著细化合金的晶粒尺寸。随着Ti含量增加，合金的晶粒尺寸呈先降低后增加的趋势，当添加(质量分数，下同)0.6%的Ti时，合金平均晶粒尺寸仅为235μm

与未添加Ti的合金相比降低了67.6%。随着Ti含量增加，合金的抗拉强度和伸长率均呈先提高后降低的趋势，当添加0.6%的Ti时，合金的抗拉强度和伸长率均达到最大值，分别为213 MPa和7.9%

相比未添加Ti的合金提高了20.3%和54.9%。

Abstract

The effects of Ti on the microstructure and mechanical properties of Mg

97.75

1.5

0.75

alloy reinforced by long period stacking ordered（LPSO） phase were investigated. The results show that the grains in the alloys are refined by Ti addition. The average grain size of the alloys is decreased at first and then increased with increasing in Ti contents. With 0.6% Ti addition

the average grain size of the alloy reaches 235 μm

which is decreased by 67.6% compared with that of the Mg

97.75

1.5

0.75

alloy. With the increase of Ti contents

the tensile strength and elongation of the alloys are decreased at first and then increased. With 0.6% Ti addition

the tensile strength and elongation of the alloy reach 213 MPa and 7.9%

which is increased by 20.3% and 54.9%

respectively

compared with those of the Mg

97.75

1.5

0.75

alloy.

关键词

TiMg97.75Er1.5Ni0.75合金组织力学性能

Keywords

TiMg97.75Er1.5Ni0.75 AlloyMicrostructureMechanical Properties

references

文章被引用时，请邮件提醒。

提交

Ti对Mg_95.5Y₃Cu_1.5合金组织和力学性能的影响

耐热Al-Ce合金的组织和力学性能

La和Ce对Al-3Si-0.5Cu-0.7Fe合金组织及性能的影响

复合变质对AlSi7Mg合金组织和性能的影响