某薄壁壳体精密成形工艺数值模拟

姚宇康; 冯再新; 郭小森; 王兴雷; 左森; 李健

doi:10.15980/j.tzzz.2022.05.021

研究·计算机应用 | 浏览量 : 0 下载量: 23 CSCD: 0

PDF
导出
分享
收藏
专辑

某薄壁壳体精密成形工艺数值模拟
Numerical Simulation of Precision Forming Process for a Thin-walled Shell
2022年42卷第5期页码：627-630
纸质出版日期： 2022 ，
DOI： 10.15980/j.tzzz.2022.05.021

扫描看全文

姚宇康, 冯再新, 郭小森, 等. 某薄壁壳体精密成形工艺数值模拟[J]. 特种铸造及有色合金, 2022,42(5):627-630.

Yao Yukang, Feng Zaixin, Guo Xiaosen, et al. Numerical Simulation of Precision Forming Process for a Thin-walled Shell[J]. Special Casting & Nonferrous Alloys, 2022,42(5):627-630.
姚宇康, 冯再新, 郭小森, 等. 某薄壁壳体精密成形工艺数值模拟[J]. 特种铸造及有色合金, 2022,42(5):627-630. DOI： 10.15980/j.tzzz.2022.05.021.

Yao Yukang, Feng Zaixin, Guo Xiaosen, et al. Numerical Simulation of Precision Forming Process for a Thin-walled Shell[J]. Special Casting & Nonferrous Alloys, 2022,42(5):627-630. DOI： 10.15980/j.tzzz.2022.05.021.

摘要

某异形壳体尺寸大、材料昂贵，材料利用率仅10%左右，加工成本居高不下。为提高材料利用率，在分析其结构特点的基础上，设计了新的成形工艺方案：下料-底部成形-薄壁成形-拉深-机加。在底部成形过程中分别设计了冲孔-翻孔-挤压法和连皮法；在薄壁成形时以减小加工余量的方式提高材料利用率。利用数值模拟方法，分析不同方案、不同坯料厚度及不同部分成形过程中的行程载荷、等效应力等，根据实际条件选择合适的工艺方案，最终使其材料利用率提高了4倍。

Abstract

The processing cost of a special shaped shell is high as a result of large size

expersive material and only about 10% in material utitization. In order to improve the utilization rate of materials

a new forming scheme was designed based on its structural characteristics: blanking-bottom forming-thin wall part forming-deep drawing-mechanical processing. In the process of bottom forming

the punching-turning-squeeze method and even skin method were designed

respectively. In thin wall forming

the material utilization rate could be improved by reducing machining allowance. Using numerical simulation method to analyze the load

equivalent stress in different solutions

different blank thickness and different part

appropriate process was chosen according to the practical conditions to improve the material utilization by 4 times.