车用水箱弯管接头熔模铸件工艺优化

丁华锋; 金先志; 陈涛; 潘俊杰

doi:10.15980/j.tzzz.2022.02.025

应用·精密铸造 | 浏览量 : 0 下载量: 81 CSCD: 0

PDF
导出
分享
收藏
专辑

车用水箱弯管接头熔模铸件工艺优化
Investment Casting Process Optimization of Water Tank Elbow Joint for Vehicle
2022年42卷第2期页码：248-252
纸质出版日期： 2022 ，
DOI： 10.15980/j.tzzz.2022.02.025

扫描看全文

丁华锋, 金先志, 陈涛, 等. 车用水箱弯管接头熔模铸件工艺优化[J]. 特种铸造及有色合金杂志, 2022,42(2):248-252.

Ding Huafeng, Jin Xianzhi, Chen Tao, et al. Investment Casting Process Optimization of Water Tank Elbow Joint for Vehicle[J]. Special Casting & Nonferrous Alloys, 2022,42(2):248-252.
丁华锋, 金先志, 陈涛, 等. 车用水箱弯管接头熔模铸件工艺优化[J]. 特种铸造及有色合金杂志, 2022,42(2):248-252. DOI： 10.15980/j.tzzz.2022.02.025.

Ding Huafeng, Jin Xianzhi, Chen Tao, et al. Investment Casting Process Optimization of Water Tank Elbow Joint for Vehicle[J]. Special Casting & Nonferrous Alloys, 2022,42(2):248-252. DOI： 10.15980/j.tzzz.2022.02.025.

摘要

经验法熔模铸造成形的弯管接头零件在通孔内壁和底座圈上都普遍存在缩松。利用ProCAST软件，对弯管接头铸件进行缺陷分析，分别从浇注系统的优化和增设冒口及冷铁入手，研究两种可以降低铸件缩松率的方案。对比发现，对浇注系统进行优化为最优方案，并在此基础上设计了正交试验。结果表明，在浇注温度为1 520℃、浇注速度为0.6 kg/s、型壳预热温度为1 120℃下，缩松率最大为1.44%

有效提高了产品品质。

Abstract

The shrinkage porosities in elbow joint parts formed by empirical investment casting generally exists on the inner wall of hole and base ring. The ProCAST simulation software was utilized to analyze the defects of elbow joint castings. With the optimization of gating system and the addition of riser and cold iron

two schemes for reducing the shrinkage rate were proposed. The comparative analysis reveals that the optimization of gating system is the optimal scheme and the orthogonal test is designed. The results indicate that when the pouring temperature is 1 520 ℃

pouring speed is 0.6 kg/s and shell preheating temperature is 1 120 ℃

the maximum shrinkage rate is 1.44%

effectively improving the quality of the product.