G10MnMoV6-3大型索夹消失模铸造关键技术和质量控制要点

杨世杰; 黄韬睿; 王雷; 李文德; 沈佳勇

doi:10.15980/j.tzzz.2021.08.023

应用·消失模铸造 | 浏览量 : 0 下载量: 7 CSCD: 0

导出
分享
收藏
专辑

G10MnMoV6-3大型索夹消失模铸造关键技术和质量控制要点
Key Technology and Quality Control for Large G10MnMoV6-3 Cable Node by Lost Foam Casting
2021年41卷第8期页码：1037-1040
纸质出版日期： 2021 ，
DOI： 10.15980/j.tzzz.2021.08.023

扫描看全文

杨世杰, 黄韬睿, 王雷, 等. G10MnMoV6-3大型索夹消失模铸造关键技术和质量控制要点[J]. 特种铸造及有色合金杂志, 2021,41(8):1037-1040.

Yang Shijie, Huang Taorui, Wang Lei, et al. Key Technology and Quality Control for Large G10MnMoV6-3 Cable Node by Lost Foam Casting[J]. Special Casting & Nonferrous Alloys, 2021,41(8):1037-1040.
杨世杰, 黄韬睿, 王雷, 等. G10MnMoV6-3大型索夹消失模铸造关键技术和质量控制要点[J]. 特种铸造及有色合金杂志, 2021,41(8):1037-1040. DOI： 10.15980/j.tzzz.2021.08.023.

Yang Shijie, Huang Taorui, Wang Lei, et al. Key Technology and Quality Control for Large G10MnMoV6-3 Cable Node by Lost Foam Casting[J]. Special Casting & Nonferrous Alloys, 2021,41(8):1037-1040. DOI： 10.15980/j.tzzz.2021.08.023.

摘要

介绍了卡塔尔2022年世界杯体育场屋面G10MnMoV6-3低合金钢大型索夹的化学成分和力学性能要求

通过采用消失模铸造工艺制造了索夹

发现了浇注过程中的难点

提出了制模和造型、冶炼与浇注、热处理等重要环节的质量控制措施。结果表明

消失模铸造索夹化学性能成分和力学性能合格

满足欧标相关要求。

Abstract

The requirements for chemical composition and mechanical properties of large G10 MnMoV6-3 low alloy steel cable node in Qatar 2022 World Cup stadium project were introduced.The cable node prototype was fabricated by lost foam casting

and the main difficulties during the process were discovered. The key points of quality control such as moulding and modeling

smelting and casting

heat treatment in the casting process were put forward.The results indicate that the chemical and mechanical properties of the cable node by lost foam casting are qualified

meeting the project requirements and the European standards.