Sc含量对ZL101合金组织和力学性能的影响

研究·合金性能 | 浏览量 : 0 下载量: 0 CSCD: 0

Sc含量对ZL101合金组织和力学性能的影响
Effects of Sc Content on Microstructure and Mechanical Properties of ZL101 Alloy
2021年41卷第6期页码：726-730
纸质出版日期： 2021 ，
DOI： 10.15980/j.tzzz.2021.06.013

扫描看全文

[1]石博,崔晓明,王伟,白朴存.Sc含量对ZL101合金组织和力学性能的影响[J].特种铸造及有色合金,2021,41(06):726-730.

Shi Bo, Cui Xiaoming, Wang Wei, et al. Effects of Sc Content on Microstructure and Mechanical Properties of ZL101 Alloy[J]. Special Casting & Nonferrous Alloys, 2021,41(6):726-730.
[1]石博,崔晓明,王伟,白朴存.Sc含量对ZL101合金组织和力学性能的影响[J].特种铸造及有色合金,2021,41(06):726-730. DOI： 10.15980/j.tzzz.2021.06.013.

Shi Bo, Cui Xiaoming, Wang Wei, et al. Effects of Sc Content on Microstructure and Mechanical Properties of ZL101 Alloy[J]. Special Casting & Nonferrous Alloys, 2021,41(6):726-730. DOI： 10.15980/j.tzzz.2021.06.013.

通过OM、SEM、TEM研究了不同Sc含量对ZL101合金组织和力学性能的影响。结果表明

当Sc含量为0.3%时能显著细化α-Al晶粒

改善共晶Si形貌

此时合金的硬度（HRC）、抗拉强度、伸长率均达到最大值

分别为29、197.95 MPa、11.06%。在ZL101合金中添加Sc后

合金会生成Al

Sc相

形成异质核心

显著细化晶粒尺寸。

The effects of different Sc contents on microstructure and mechanical properties of Zl101 alloy were investigated by OM

SEM and TEM. The results reveal that when the Sc content is 0.3%

the grain size of α-Al can be refined and the morphology of eutectic silicon can be improved. Meanwhile

the Rockwell hardness（HRC）

tensile strength and elongation of the alloy reach maximum values of 29

197.95 MPa and 11.06%. After adding Sc in ZL101 alloy

Sc phase can be generated to act as heterogeneous nuclei to refine grain size remarkably.

ScZL101合金微观组织力学性能

ScZL101 AlloyMicrostructureMechanical Properties

文章被引用时，请邮件提醒。

提交