泵体压铸工艺设计及参数优化

应用·压力铸造 | 浏览量 : 0 下载量: 49 CSCD: 0

扫描看全文

刘芳, 平娟, 陈锡渠. 泵体压铸工艺设计及参数优化[J]. 特种铸造及有色合金杂志, 2021,41(5):644-648.

Liu Fang, Ping Juan, Chen Xiqu. Design and Optimized Parameters of Die Casting Process for Pump Body[J]. Special Casting & Nonferrous Alloys, 2021,41(5):644-648.
刘芳, 平娟, 陈锡渠. 泵体压铸工艺设计及参数优化[J]. 特种铸造及有色合金杂志, 2021,41(5):644-648. DOI： 10.15980/j.tzzz.2021.05.026.

Liu Fang, Ping Juan, Chen Xiqu. Design and Optimized Parameters of Die Casting Process for Pump Body[J]. Special Casting & Nonferrous Alloys, 2021,41(5):644-648. DOI： 10.15980/j.tzzz.2021.05.026.

分析泵体结构

设计泵体压铸工艺

以压射速度、浇注温度、模具预热温度为因素建立正交试验

采用ProCAST软件进行数值模拟

分析铸件产生的卷气和缩孔缺陷原因。结果表明

当压射速度为2.5 m/s、浇注温度为660℃、模具预热温度为230℃时

铸件产生的卷气和缩孔缺陷最少

并采用该优化参数进行试生产

获得了合格的产品。

Based on the structure of the pump body

die casting process was designed and simulated by the ProCAST software. Taking injection speed

pouring temperature

mold preheating temperature as factors

the orthogonal expriment was designed. Through analyzing the air entrainment and shrinkage defects in the pump body

the results reveal that there exists the least air entrainment and shrinkage defects with 2.5 m/s of injection speed

660 ℃ of pouring temperature and 230 ℃ of mold preheating temperature. Using the optimized parameters

the qualified pump body was produced successfully

meeting the actual requirement.

泵体压铸工艺设计数值模拟工艺参数优化

Pump BodyDie Casting Process DesignNumerical SimulationOptimized Parameters

文章被引用时，请邮件提醒。

提交