基于Creo的铸造浇注系统参数化自动建模技术

刘颖卓; 崔恩强; 崔宇翔; 邹文兵

doi:10.15980/j.tzzz.2021.05.013

研究·计算机应用 | 浏览量 : 0 下载量: 48 CSCD: 0

PDF
导出
分享
收藏
专辑

基于Creo的铸造浇注系统参数化自动建模技术
Automatic Modeling Technology of Casting Gating System Parameterization Based on Creo Parametric
2021年41卷第5期页码：584-587
纸质出版日期： 2021 ，
DOI： 10.15980/j.tzzz.2021.05.013

扫描看全文

刘颖卓, 崔恩强, 崔宇翔, 等. 基于Creo的铸造浇注系统参数化自动建模技术[J]. 特种铸造及有色合金杂志, 2021,41(5):584-587.

Liu Yingzhuo, Cui Enqiang, Cui Yuxiang, et al. Automatic Modeling Technology of Casting Gating System Parameterization Based on Creo Parametric[J]. Special Casting & Nonferrous Alloys, 2021,41(5):584-587.
刘颖卓, 崔恩强, 崔宇翔, 等. 基于Creo的铸造浇注系统参数化自动建模技术[J]. 特种铸造及有色合金杂志, 2021,41(5):584-587. DOI： 10.15980/j.tzzz.2021.05.013.

Liu Yingzhuo, Cui Enqiang, Cui Yuxiang, et al. Automatic Modeling Technology of Casting Gating System Parameterization Based on Creo Parametric[J]. Special Casting & Nonferrous Alloys, 2021,41(5):584-587. DOI： 10.15980/j.tzzz.2021.05.013.

摘要

针对建模复杂的零件浇注系统

在Creo环境下基于参数化自动建模设计进行二次开发。以族表技术为依托

并结合Pro/TOOLKIT进行二次开发

介绍了进行参数化自动建模的关键技术和开发步骤

弥补了通过族表自动建模的自由性和交互性差的缺陷。通过上述参数化自动建模

大大提高了建模速度

从整体上提高了设计效率。

Abstract

In view of complex modeling gating system

the parametric automatic modeling design was performed in the Creo environment for secondary development. Based on family table technology and combined with Pro/TOOLKIT for secondary development

the key technologies and development steps of parametric automatic modeling were introduced

making up for the defects of freedom and poor interaction of automatic modeling through family table. The modeling speed was greatly improved

and the design efficiency was increased overall via the above parametric automatic modeling.