冷却速率对石膏型铸造铝合金组织及性能的影响

徐超; 张国伟; 牛经纬

doi:10.15980/j.tzzz.2020.12.014

精密铸造 | 浏览量 : 0 下载量: 56 CSCD: 0

导出
分享
收藏
专辑

冷却速率对石膏型铸造铝合金组织及性能的影响
Effects of Cooling Rate on Microstructure and Mechanical Properties of Plaster Casting Aluminum Alloy
2020年40卷第12期页码：1376-1379
纸质出版日期： 2020 ，
DOI： 10.15980/j.tzzz.2020.12.014

扫描看全文

[1]徐超,张国伟,牛经纬.冷却速率对石膏型铸造铝合金组织及性能的影响[J].特种铸造及有色合金,2020,40(12):1376-1379.

Xu Chao, Zhang Guowei, Niu Jingwei. Effects of Cooling Rate on Microstructure and Mechanical Properties of Plaster Casting Aluminum Alloy[J]. Special Casting & Nonferrous Alloys, 2020,40(12):1376-1379.
[1]徐超,张国伟,牛经纬.冷却速率对石膏型铸造铝合金组织及性能的影响[J].特种铸造及有色合金,2020,40(12):1376-1379. DOI： 10.15980/j.tzzz.2020.12.014.

Xu Chao, Zhang Guowei, Niu Jingwei. Effects of Cooling Rate on Microstructure and Mechanical Properties of Plaster Casting Aluminum Alloy[J]. Special Casting & Nonferrous Alloys, 2020,40(12):1376-1379. DOI： 10.15980/j.tzzz.2020.12.014.

摘要

研究了不同冷却速率对石膏型铸造ZL205A铝合金不同壁厚位置处的显微组织及力学性能变化。结果表明

随着冷却速率提高

合金的晶粒明显细化;当冷却速率较小时

不同壁厚处合金的晶粒尺寸和力学性能存在梯度差

提高冷却速率

可以使铸件各部位显微组织和力学性能变均匀;当放置30mm厚冷铁时

铸件各部位平均晶粒尺寸最小

约为70μm

抗拉强度达389.8 MPa

但伸长率仅为5.4%。

Abstract

The effects of different cooling rates on the microstructure and mechanical properties at different wall thickness locations of the plaster casting ZL205 Aalloy were investigated.The results indicate that the grain size of alloy is obviously refined with the increase of the cooling rate.When the cooling rate is low

the grain size and mechanical properties of the alloy exist gradients at different wall thicknesses

and microstructure and mechanical properties of each part of the alloy can be fairly well-distributed by increasing the cooling rate.When a 30 mm thick cold iron is placed

the average grain size of each part of alloy reach 70μm

and the average tensile strength reaches 389.8 MPa

while the elongation is only 5.4%.