消失模铸造灰铸铁的组织与力学性能

陈忠士; 邹泽昌; 邱智泉; 李耀朋; 占菊凤

doi:10.15980/j.tzzz.2020.09.016

消失模与V法铸造 | 浏览量 : 0 下载量: 136 CSCD: 0

导出
分享
收藏
专辑

消失模铸造灰铸铁的组织与力学性能
Microstructure and Mechanical Properties of Gray Cast Iron Parts by Lost Foam Casting
2020年40卷第9期页码：996-999
纸质出版日期： 2020 ，
DOI： 10.15980/j.tzzz.2020.09.016

扫描看全文

[1]陈忠士,邹泽昌,邱智泉,李耀朋,占菊凤.消失模铸造灰铸铁的组织与力学性能[J].特种铸造及有色合金,2020,40(09):996-999.

Chen Zhongshi, Zou Zechang, Qiu Zhiquan, et al. Microstructure and Mechanical Properties of Gray Cast Iron Parts by Lost Foam Casting[J]. Special Casting & Nonferrous Alloys, 2020,40(9):996-999.
[1]陈忠士,邹泽昌,邱智泉,李耀朋,占菊凤.消失模铸造灰铸铁的组织与力学性能[J].特种铸造及有色合金,2020,40(09):996-999. DOI： 10.15980/j.tzzz.2020.09.016.

Chen Zhongshi, Zou Zechang, Qiu Zhiquan, et al. Microstructure and Mechanical Properties of Gray Cast Iron Parts by Lost Foam Casting[J]. Special Casting & Nonferrous Alloys, 2020,40(9):996-999. DOI： 10.15980/j.tzzz.2020.09.016.

摘要

探讨了消失模铸造与粘土砂型铸造条件下的普通灰铸铁（HT200）与孕育铸铁（HT250）的石墨形态、基体组织和力学性能。结果表明

与粘土砂型铸造相比

采用相同化学成分的铁水和相同的浇注条件

消失模铸造条件下形成的A形片状石墨粗大

石墨长度更长;基体组织中铁素体含量增大;抗拉强度与硬度均低于粘土砂铸造的。因此

采用消失模铸造工艺时

为了保证铸件本体的力学性能

应根据铸件结构和壁厚等因素

结合铸件牌号要求和生产条件

采取相应的强化措施。

Abstract

The graphite morphology

base structure and mechanical properties of common grey cast iron（HT200）and inoculated cast iron（HT250）in LFC and in clay sand casting were investigated.The results show that the microstructure and mechanical properties of EPC are different from those of clay sand casting under the same chemical composition and pouring conditions.The A-shaped flake graphite formed by LFC is more coarse and longer

and the content of ferrite in the matrix is increased

and both the tensile strength and hardness are lower than those of clay sand casting.Therefore

the corresponding strengthening measures should be taken into account according to the casting structure

wall thickness

casting brand requirements and production conditions to ensure the mechanical properties of the castings when LFC process is adopted.