减少压铸模裂纹的工艺研究与应用

陈剑虹; 涉泽明秀; 汪学阳; 安肇勇; 黄志垣

doi:10.15980/j.tzzz.2020.08.009

压力铸造 | 浏览量 : 0 下载量: 57 CSCD: 0

导出
分享
收藏
专辑

减少压铸模裂纹的工艺研究与应用
Research and Application of Technology to Reducing Die-casting Die Cracks
2020年40卷第8期页码：851-853
纸质出版日期： 2020 ，
DOI： 10.15980/j.tzzz.2020.08.009

扫描看全文

[1]陈剑虹,涉泽明秀,汪学阳,安肇勇,黄志垣.减少压铸模裂纹的工艺研究与应用[J].特种铸造及有色合金,2020,40(08):851-853.

Research and Application of Technology to Reducing Die-casting Die Cracks[J]. Special Casting & Nonferrous Alloys, 2020,40(8):851-853.
[1]陈剑虹,涉泽明秀,汪学阳,安肇勇,黄志垣.减少压铸模裂纹的工艺研究与应用[J].特种铸造及有色合金,2020,40(08):851-853. DOI： 10.15980/j.tzzz.2020.08.009.

Research and Application of Technology to Reducing Die-casting Die Cracks[J]. Special Casting & Nonferrous Alloys, 2020,40(8):851-853. DOI： 10.15980/j.tzzz.2020.08.009.

摘要

为减少压铸模裂纹的产生

延长压铸模使用寿命

采用普通热作模具钢及高钼热作模具钢

试验了其开始产生龟裂纹的模次。考查两种模具钢表面氮化后开始出现龟裂纹的模次及龟裂纹的深度

并对模具加工的残余应力进行了分析。结果表明

相同产品、相同生产条件下

做了气体表面氮化的模具寿命比不处理模具寿命延长53%～75%。

Abstract

In order to reduce the occurrence of die casting cracks and prolong the service life of die casting dies

ordinary hot mold steels and high molybdenum hot mold steels were used to test the modulus of cracks

the mould cycles and depth of crack after nitriding on two surfaces. The residual stress of die during processing was also analyzed. The results show that the die life with surface nitriding treatment can be prolonged by 53%～75% compared with that of one without nitriding treatment at the same product and production conditions.