血管支架镁合金表面氟化镁涂层的制备与性能

侯树森; 郭贵中; 王广龙; 李文星; 李悦

doi:10.15980/j.tzzz.2020.08.005

实用研究 | 浏览量 : 0 下载量: 142 CSCD: 0

导出
分享
收藏
专辑

血管支架镁合金表面氟化镁涂层的制备与性能
Preparation and Performance of Magnesium Fluoride Coating on Magnesium Alloy for Stent Application
2020年40卷第8期页码：832-836
纸质出版日期： 2020 ，
DOI： 10.15980/j.tzzz.2020.08.005

扫描看全文

[1]侯树森,郭贵中,王广龙,李文星,李悦.血管支架镁合金表面氟化镁涂层的制备与性能[J].特种铸造及有色合金,2020,40(08):832-836.

Hou Shusen, Guo Guizhong, Wang Guanglong, et al. Preparation and Performance of Magnesium Fluoride Coating on Magnesium Alloy for Stent Application[J]. Special Casting & Nonferrous Alloys, 2020,40(8):832-836.
[1]侯树森,郭贵中,王广龙,李文星,李悦.血管支架镁合金表面氟化镁涂层的制备与性能[J].特种铸造及有色合金,2020,40(08):832-836. DOI： 10.15980/j.tzzz.2020.08.005.

Hou Shusen, Guo Guizhong, Wang Guanglong, et al. Preparation and Performance of Magnesium Fluoride Coating on Magnesium Alloy for Stent Application[J]. Special Casting & Nonferrous Alloys, 2020,40(8):832-836. DOI： 10.15980/j.tzzz.2020.08.005.

摘要

针对医用镁合金在生理环境下降解过快的问题

用化学转化法在镁合金表面制备了氟化镁涂层

以减缓镁合金血管支架的降解速率。分析了HF酸浓度、处理时间对转化涂层的成分、脆性以及耐腐蚀性的影响。结果表明

氟化镁涂层的厚度随HF酸处理时间延长而增大

但脆性也增大;较高的HF酸浓度下涂层的脆性较低

耐腐蚀性较好;HF酸浓度为40%、处理6 h后所得涂层具有最好的综合性能。

Abstract

In order to reduce the degradation rate of magnesium alloy stents

magnesium fluoride coating was prepared on the surface of magnesium alloy by chemical conversion. The effects of hydrofluoric acid concentration and treatment time on the composition

brittleness and corrosion resistance of the coatings were investigated. The results indicate that the thickness of magnesium fluoride coating is increased with the treatment time

while the brittleness is also increased. In addition

the brittleness of the coating in a higher hydrofluoric acid concentration are lower

so the corrosion resistance presents better. The coating presents the satisfied comprehensive performance with hydrofluoric acid concentration of 40% at treatment of 6 h.