铝合金薄壁壳体低压铸造工艺研究

李栋; 曾建民; 马原; 梁继亚

doi:10.15980/j.tzzz.2020.04.012

压力铸造 | 浏览量 : 0 下载量: 203 CSCD: 1

导出
分享
收藏
专辑

铝合金薄壁壳体低压铸造工艺研究
Production of Thin-walled Alloy Castings Based on Low Pressure Integrated with 3D Printing
2020年40卷第4期页码：398-400
纸质出版日期： 2020 ，
DOI： 10.15980/j.tzzz.2020.04.012

扫描看全文

[1]李栋,曾建民,马原,梁继亚.铝合金薄壁壳体低压铸造工艺研究[J].特种铸造及有色合金,2020,40(04):398-400.

Li Dong, Zeng Jianmin, Ma Yuan, et al. Production of Thin-walled Alloy Castings Based on Low Pressure Integrated with 3D Printing[J]. Special Casting & Nonferrous Alloys, 2020,40(4):398-400.
[1]李栋,曾建民,马原,梁继亚.铝合金薄壁壳体低压铸造工艺研究[J].特种铸造及有色合金,2020,40(04):398-400. DOI： 10.15980/j.tzzz.2020.04.012.

Li Dong, Zeng Jianmin, Ma Yuan, et al. Production of Thin-walled Alloy Castings Based on Low Pressure Integrated with 3D Printing[J]. Special Casting & Nonferrous Alloys, 2020,40(4):398-400. DOI： 10.15980/j.tzzz.2020.04.012.

摘要

主体壁厚为3mm的铝合金壳体铸件

成形比较困难。因此

设计两种方案

利用3D打印砂型进行低压铸造浇注验证。结果表明

选择合适的浇注位置并设计合理的浇注系统

有利于薄壁铸件的成形

并利用CAE软件模拟优选出合理的铸造工艺方案。

Abstract

It is difficult to manufacture wall thickness of 3 mm and complex shape aluminum alloy.castings 3DP sand mould combined with low-pressure casting was adopted to produce the aluminum alloy housing with two design schemes.The results reveal that it is beneficial for forming thin-walled aluminum alloy housing through selecting rational pouring position and designing proper gating system.Meanwhile

the optimized process was determined based on the CAE analysis.