挤压铸造件力学性能影响因素及交互作用研究

曹一明; 刘永姜; 张雅丽; 许向川

doi:10.15980/j.tzzz.2019.10.012

压力铸造 | 浏览量 : 0 下载量: 103 CSCD: 4

导出
分享
收藏
专辑

挤压铸造件力学性能影响因素及交互作用研究
Influencing Factors and Interaction Effects of Mechanical Properties of Squeeze Casting Parts
2019年39卷第10期页码：1087-1089
纸质出版日期： 2019 ，
DOI： 10.15980/j.tzzz.2019.10.012

扫描看全文

[1]曹一明,刘永姜,张雅丽,许向川.挤压铸造件力学性能影响因素及交互作用研究[J].特种铸造及有色合金,2019,39(10):1087-1089.

Cao Yiming, Liu Yongjiang, Zhang Yali, et al. Influencing Factors and Interaction Effects of Mechanical Properties of Squeeze Casting Parts[J]. Special Casting & Nonferrous Alloys, 2019,39(10):1087-1089.
[1]曹一明,刘永姜,张雅丽,许向川.挤压铸造件力学性能影响因素及交互作用研究[J].特种铸造及有色合金,2019,39(10):1087-1089. DOI： 10.15980/j.tzzz.2019.10.012.

Cao Yiming, Liu Yongjiang, Zhang Yali, et al. Influencing Factors and Interaction Effects of Mechanical Properties of Squeeze Casting Parts[J]. Special Casting & Nonferrous Alloys, 2019,39(10):1087-1089. DOI： 10.15980/j.tzzz.2019.10.012.

摘要

为优化挤压铸造工艺参数

改善铸件的力学性能

选取浇注温度、挤压压力和保压时间作为优化变量

抗拉强度、硬度和伸长率作为响应性能指标

采用响应曲面分析法

建立相对应的预测回归模型并进行方差分析

得出各参数及其交互作用对力学性能的影响。利用Design-Expert软件优化后得到了各工艺参数间的最优组合:浇注温度为750℃

挤压压力为150MPa

保压时间为21.37s。

Abstract

In order to optimize the extrusion casting process parameters and improve mechanical properties of the squeezing casting parts

the casting temperature（A）

extrusion pressure（B）and holding time（C）were selected as the optimization variables

tensile strength

hardness and elongation as response performance indicators.The response surface analysis method was adopted to establish the corresponding predictive regression model and carry out analysis of variance to obtain the affecting significance of various parameters and their interaction effects on the mechanical properties of the squeezing castings.The optimized combination of process parameters was obtained by using Design-Expert software as follows:pouring temperature of 750℃

extrusion pressure of 150 MPa and holding time of 21.37 s.