基于FLOW-3D的减震塔真空压铸工艺设计与优化

吴耀荣; 岑伟明; 邓宇斌; 梁富

doi:10.15980/j.tzzz.2019.06.009

压力铸造 | 浏览量 : 0 下载量: 79 CSCD: 2

导出
分享
收藏
专辑

基于FLOW-3D的减震塔真空压铸工艺设计与优化
Design and Optimization of Die Casting Process for Vacuum Die Casting Shocking Tower Based on Flow-3D Software
2019年39卷第6期页码：618-621
纸质出版日期： 2019 ，
DOI： 10.15980/j.tzzz.2019.06.009

扫描看全文

[1]吴耀荣,岑伟明,邓宇斌,梁富.基于FLOW-3D的减震塔真空压铸工艺设计与优化[J].特种铸造及有色合金,2019,39(06):618-621.

Wu Yaorong, Cen Weiming, Deng Yubin, et al. Design and Optimization of Die Casting Process for Vacuum Die Casting Shocking Tower Based on Flow-3D Software[J]. Special Casting & Nonferrous Alloys, 2019,39(6):618-621.
[1]吴耀荣,岑伟明,邓宇斌,梁富.基于FLOW-3D的减震塔真空压铸工艺设计与优化[J].特种铸造及有色合金,2019,39(06):618-621. DOI： 10.15980/j.tzzz.2019.06.009.

Wu Yaorong, Cen Weiming, Deng Yubin, et al. Design and Optimization of Die Casting Process for Vacuum Die Casting Shocking Tower Based on Flow-3D Software[J]. Special Casting & Nonferrous Alloys, 2019,39(6):618-621. DOI： 10.15980/j.tzzz.2019.06.009.

摘要

基于Flow-3D软件

分析了工艺设计过程

利用模拟分析软件

经过多次模流的相互对比和分析

确定了减震塔铸件的浇注方案。根据该方案模拟抽真空的状态

经过模拟分析

预测其可能产生的缺陷及位置

并提出相应的改进措施。

Abstract

The optimized gating system was determined for the vacuum die casting shocking tower based on the Flow-3 Dsoftware with different editions to analyze comparatively the gating system design.Through simulation analysis

the potential defects in the shocking tower during filling and solidification process were visualized

and the optimized structure in the mould design was conducted.