CuCrZr导电合金的制备方法与性能关系

焦承东; 李宾; 田兴强

doi:10.15980/j.tzzz.2018.11.028

重有色合金 | 浏览量 : 0 下载量: 173 CSCD: 1

导出
分享
收藏
专辑

CuCrZr导电合金的制备方法与性能关系
Relationship between Preparation and Properties of CuCrZr Alloy
2018年38卷第11期页码：1268-1270
纸质出版日期： 2018 ，
DOI： 10.15980/j.tzzz.2018.11.028

扫描看全文

[1]焦承东,李宾,田兴强.CuCrZr导电合金的制备方法与性能关系[J].特种铸造及有色合金,2018,38(11):1268-1270.

Jiao Chengdong, Li Bin, Tian Xingqiang. Relationship between Preparation and Properties of CuCrZr Alloy[J]. Special Casting & Nonferrous Alloys, 2018,38(11):1268-1270.
[1]焦承东,李宾,田兴强.CuCrZr导电合金的制备方法与性能关系[J].特种铸造及有色合金,2018,38(11):1268-1270. DOI： 10.15980/j.tzzz.2018.11.028.

Jiao Chengdong, Li Bin, Tian Xingqiang. Relationship between Preparation and Properties of CuCrZr Alloy[J]. Special Casting & Nonferrous Alloys, 2018,38(11):1268-1270. DOI： 10.15980/j.tzzz.2018.11.028.

摘要

分别采用直接冶炼法、包覆添加法与合金添加法制备了CuCrZr合金

并通过相同的热处理方法与后续加工方法

制备成螺旋弹簧

并对其性能进了测试。结果发现

合金添加法制备的CuCrZr合金具有良好的抗拉强度与弹性模量

分别约为493MPa与180GPa;其抗压变性能良好

螺旋角为60°

回弹后与短轴差值最小

具有优良的导电性能。

Abstract

CuCrZr alloys were prepared by alloy addition method

directly melting and cladding addition method

and spiral springs were produced based on the same heat treatment and subsequent processing.In addition

the properties of the spiral spring produced were tested.The results show that the alloy prepared by the alloying addition has good tensile strength and elasticity modulus

which is about 493 MPa and 180 GPa

respectively

and its compressive resistance exhibits desirable

where the helix angle is 60 degrees

and difference of short axis is the smallest before and after the test

showing the satisfied electrical conductivity performance.