基于Flow-3D的ES6W水泵壳体压铸工艺设计及优化

胡号; 许磊; 王凯; 历长云; 米国发; 王涛

doi:10.15980/j.tzzz.2018.06.011

压力铸造 | 浏览量 : 0 下载量: 97 CSCD: 3

导出
分享
收藏
专辑

基于Flow-3D的ES6W水泵壳体压铸工艺设计及优化
Design and Optimization of Die Casting Process for ES6W Pump Shell based on Flow-3D
2018年38卷第6期页码：619-622
纸质出版日期： 2018 ，
DOI： 10.15980/j.tzzz.2018.06.011

扫描看全文

[1]胡号,许磊,王凯,历长云,米国发,王涛.基于Flow-3D的ES6W水泵壳体压铸工艺设计及优化[J].特种铸造及有色合金,2018,38(06):619-622.

Hu Hao, Xu Lei, Wang Kai, et al. Design and Optimization of Die Casting Process for ES6W Pump Shell based on Flow-3D[J]. Special Casting & Nonferrous Alloys, 2018,38(6):619-622.
[1]胡号,许磊,王凯,历长云,米国发,王涛.基于Flow-3D的ES6W水泵壳体压铸工艺设计及优化[J].特种铸造及有色合金,2018,38(06):619-622. DOI： 10.15980/j.tzzz.2018.06.011.

Hu Hao, Xu Lei, Wang Kai, et al. Design and Optimization of Die Casting Process for ES6W Pump Shell based on Flow-3D[J]. Special Casting & Nonferrous Alloys, 2018,38(6):619-622. DOI： 10.15980/j.tzzz.2018.06.011.

摘要

根据水泵壳体的结构特点和品质要求

设计了水泵壳体压铸工艺方案。利用Flow-3D软件对初始工艺方案的充型及凝固过程进行数值模拟

分析了初始工艺方案产生缺陷的部位和原因。针对这些问题

采取了扩大内浇口和在缺陷严重的部位添加溢流槽的方法

设计出了优化方案。模拟结果显示

优化后的工艺使铸件上的卷气显著减少

提高了铸件品质

满足了使用要求。

Abstract

According to the structural characteristics and quality requirments of the pump shell

the design of die casting process for the pump shell was carried out.The numerical simulation of the filling and solidification process of the initial design was carried out by using Flow-3 Dsoftware

and the position and cause of the shrinkage defects were analyzed.Aiming at these problems

the method of enlarging the ingate and adding the overflow slot at the defective position was adopted

and the optimization scheme was designed.The simulation results show that the optimized process can reduce significantly the entrapped-gas in the castings and improve the casting quality to meet the requirements.