熔模铸造钛合金直齿面齿轮快速成形工艺

张浩; 白瑀; 黄亮

doi:10.15980/j.tzzz.2018.02.019

精密铸造 | 浏览量 : 0 下载量: 182 CSCD: 1

导出
分享
收藏
专辑

熔模铸造钛合金直齿面齿轮快速成形工艺
Rapid Prototyping Technology of Investment Casting Titanium Alloy Straight Tooth Gear
2018年38卷第2期页码：183-185
纸质出版日期： 2018 ，
DOI： 10.15980/j.tzzz.2018.02.019

扫描看全文

[1]张浩,白瑀,黄亮.熔模铸造钛合金直齿面齿轮快速成形工艺[J].特种铸造及有色合金,2018,38(02):183-185.

Zhang Hao, Bai Yu, Huang Liang. Rapid Prototyping Technology of Investment Casting Titanium Alloy Straight Tooth Gear[J]. Special Casting & Nonferrous Alloys, 2018,38(2):183-185.
[1]张浩,白瑀,黄亮.熔模铸造钛合金直齿面齿轮快速成形工艺[J].特种铸造及有色合金,2018,38(02):183-185. DOI： 10.15980/j.tzzz.2018.02.019.

Zhang Hao, Bai Yu, Huang Liang. Rapid Prototyping Technology of Investment Casting Titanium Alloy Straight Tooth Gear[J]. Special Casting & Nonferrous Alloys, 2018,38(2):183-185. DOI： 10.15980/j.tzzz.2018.02.019.

摘要

为了解决传统减材制造钛合金直齿面齿轮工艺复杂、成本高昂、精度偏低的问题

采用基于快速铸造成形原理建立熔模铸造的试验模型。通过试验得出用于熔模精铸型壳组分配比、蒸气脱蜡、型壳焙烧、真空室离心浇注及制件后处理的具体工艺。对铸件尺寸精度和表面粗糙度检测表明

这种工艺可以铸造出精度等级达到CT4级、尺寸误差小、表面粗糙度低（4.52μm）的钛合金直齿面齿轮

并验证了工艺的可行性。

Abstract

In order to solve the sophisticated process

high cost

low precision problems in traditional subtractive manufacturing method to manufacture titanium alloy straight tooth surface gear

based on rapid casting forming

experimental model of investment casting was established.The processes such as ceramic shell ingredients ratio

steam dewaxing

shell baking

centrifugal casting in vacuum chamber and the post processing were presented.By measured the dimensional accuracy and surface roughness of the investment castings

the results show that the technology can make titanium alloy straight tooth surface gear with comprehensive precision of CT4 and small size error

low surface roughness.In addition

the feasibility of this process was verified.