铝合金蜗壳低压铸造工艺设计及数值模拟

魏娟娟; 米国发; 周志杰; 张锦志

doi:10.15980/j.tzzz.2018.02.015

压力铸造 | 浏览量 : 0 下载量: 184 CSCD: 3

导出
分享
收藏
专辑

铝合金蜗壳低压铸造工艺设计及数值模拟
Numerical Simulation and Process Design of Low Pressure Casting Aluminum Alloy Volute
2018年38卷第2期页码：172-175
纸质出版日期： 2018 ，
DOI： 10.15980/j.tzzz.2018.02.015

扫描看全文

[1]魏娟娟,米国发,周志杰,张锦志.铝合金蜗壳低压铸造工艺设计及数值模拟[J].特种铸造及有色合金,2018,38(02):172-175.

Wei Juanjuan, Mi Guofa, Zhou Zhijie, et al. Numerical Simulation and Process Design of Low Pressure Casting Aluminum Alloy Volute[J]. Special Casting & Nonferrous Alloys, 2018,38(2):172-175.
[1]魏娟娟,米国发,周志杰,张锦志.铝合金蜗壳低压铸造工艺设计及数值模拟[J].特种铸造及有色合金,2018,38(02):172-175. DOI： 10.15980/j.tzzz.2018.02.015.

Wei Juanjuan, Mi Guofa, Zhou Zhijie, et al. Numerical Simulation and Process Design of Low Pressure Casting Aluminum Alloy Volute[J]. Special Casting & Nonferrous Alloys, 2018,38(2):172-175. DOI： 10.15980/j.tzzz.2018.02.015.

摘要

利用ViewCast软件对铝合金蜗壳低压铸造工艺进行模拟分析

预测铸件内部出现缺陷的位置及大小。模拟结果显示

铸件厚大部位最后凝固

铸件内部出现缩松、缩孔缺陷。分析产生缺陷的原因

并提出优化方案。在铸件中间厚大部位设置直浇道和内浇道

增加对厚大部位的补缩。模拟结果显示

缺陷完全消除

实际生产的铸件能够满足使用要求。

Abstract

The low pressure casting process of aluminum alloy volute was simulated by Viewcast software

and the position and size of defects in the volute were predicted.The result shows that the final solidification position is located at the thick and large part

and there exist defects such as shrinkage porosities（holes）in the volute.The origination of the defect was analyzed

and a optimization scheme was proposed by adding the sprue and ingate in the middle of the gating system to increase the feeding effect of the thick and large part.The optimized results show that the defects can be eliminated completely

meeting the production requirements.