Cu-4.0Ag合金微细线制备工艺及性能研究

朱利媛; 李雷; 冀国良; 李强; 封博文; 刘光林

doi:10.15980/j.tzzz.2017.12.023

重有色合金 | 浏览量 : 0 下载量: 106 CSCD: 5

导出
分享
收藏
专辑

Cu-4.0Ag合金微细线制备工艺及性能研究
Preparation and Properties of Cu-4.0Ag Alloy Micro-fine Wires
2017年37卷第12期页码：1357-1360
纸质出版日期： 2017 ，
DOI： 10.15980/j.tzzz.2017.12.023

扫描看全文

[1]朱利媛,李雷,冀国良,李强,封博文,刘光林.Cu-4.0Ag合金微细线制备工艺及性能研究[J].特种铸造及有色合金,2017,37(12):1357-1360.

Zhu Liyuan, Li Lei, Ji Guoliang, et al. Preparation and Properties of Cu-4.0Ag Alloy Micro-fine Wires[J]. Special Casting & Nonferrous Alloys, 2017,37(12):1357-1360.
[1]朱利媛,李雷,冀国良,李强,封博文,刘光林.Cu-4.0Ag合金微细线制备工艺及性能研究[J].特种铸造及有色合金,2017,37(12):1357-1360. DOI： 10.15980/j.tzzz.2017.12.023.

Zhu Liyuan, Li Lei, Ji Guoliang, et al. Preparation and Properties of Cu-4.0Ag Alloy Micro-fine Wires[J]. Special Casting & Nonferrous Alloys, 2017,37(12):1357-1360. DOI： 10.15980/j.tzzz.2017.12.023.

摘要

提出了采用连续水平定向凝固法制备Cu-4.0Ag合金铸杆

然后用多道次连续冷拉拔的方法生产Cu-Ag合金微细线。结果表明

制备出的φ8mm铸杆具有连续纵向柱状晶组织

可不经中间退火而连续冷拉拔制备微细线。解决了传统冷型连铸制备微细线时需要多道次中间退火的问题

避免了氧化和断线。所制备的φ0.05mm的微细线强度高于1GPa

电导率为44.78 MS/m

其强化机理为Ag纤维强化。

Abstract

Aiming at the problems in preparation of the micro-fine Cu-Ag alloy wires

a method of horizontal directional solidification casting Cu-4.0 Ag alloy rod associated with continuously multi-pass cold drawing was proposed.The results reveal that the micro-fine Cu-4.0 Ag alloy wire with diameter of 0.05 mm can be prepared by continuously cold drawing of φ8 mm casting rod with continuous longitudinal columnar structures

and any intermedial annealing is canceled.The problems of requirement of several intermediate annealing process were avoided and the wire was prevented from oxidation and breakage.The strength of φ0.05 mm wire prepared is more than 1 GPa

and the conductivity reaches 44.78 MS/m.The strengthening mechanism is mainly attributed to the strengthening effects of silver fibers.