半固态搅拌法制备高含量SiC<sub>p</sub>/A356复合材料

吕国锋; 陈铨

doi:10.15980/j.tzzz.2016.12.011

半固态加工 | 浏览量 : 0 下载量: 116 CSCD: 1

导出
分享
收藏
专辑

半固态搅拌法制备高含量SiC_p/A356复合材料
Feasibility of Fabricating High SiC Content SiC_p/A356 Composites by Semi-solid Stirring Method
2016年36卷第12期页码：1279-1281
纸质出版日期： 2016 ，
DOI： 10.15980/j.tzzz.2016.12.011

扫描看全文

[1]吕国锋,陈铨.半固态搅拌法制备高含量SiC_p/A356复合材料[J].特种铸造及有色合金,2016,36(12):1279-1281.

LüGuofeng, Chen Quan. Feasibility of Fabricating High SiC Content SiC_p/A356 Composites by Semi-solid Stirring Method[J]. Special Casting & Nonferrous Alloys, 2016,36(12):1279-1281.
[1]吕国锋,陈铨.半固态搅拌法制备高含量SiC_p/A356复合材料[J].特种铸造及有色合金,2016,36(12):1279-1281. DOI： 10.15980/j.tzzz.2016.12.011.

LüGuofeng, Chen Quan. Feasibility of Fabricating High SiC Content SiC_p/A356 Composites by Semi-solid Stirring Method[J]. Special Casting & Nonferrous Alloys, 2016,36(12):1279-1281. DOI： 10.15980/j.tzzz.2016.12.011.

摘要

采用半固态机械搅拌法制备SiC

含量（质量分数）高于40%的SiC

/A356复合材料

测试了材料的密度

观察了材料的组织形貌特征。结果表明

粒度为15μm的SiC

经过特殊处理后

可以制备SiC

含量高于40%的SiC

/A356复合材料

且无明显团聚现象;随着SiC

含量从41%增加到43%

复合材料的密度从2.714g/cm3下降到2.615g/cm3

但下降趋势不完全呈线性关系。试验材料的增强相颗粒与基体结合良好

无明显的界面反应。采用半固态机械搅拌法制备SiC

含量高于40%的SiC

/A356复合材料是可行的。

Abstract

SiC

/A356 composites with 40% SiC

content was fabricated by semi-solid mechanical stirring method.The density of composites was measured

and the microstructure of the composites prepared was observed.The results indicate that special treated SiC

with 800 mesh can be used to prepare SiC

/A356 composite with more than 40% SiC

content

and the SiC

particles can be distributed uniformly in the matrix alloy.With SiC

content increasing from 41%to 43%

the density of the composites decreases from 2.714g/cm3 to 2.615g/cm3 non-linearly.The particles and the matrix exhibit the satisfied bonding effects without obvious interfacial reaction.It is feasible to use semi-solid stirring method to prepare SiC

/A356 composites with more than 40% SiC

content.