变质工艺及热处理对ADC12铝合金导电性能的影响

王剑

doi:10.15980/j.tzzz.2016.11.023

轻有色合金 | 浏览量 : 0 下载量: 115 CSCD: 1

导出
分享
收藏
专辑

变质工艺及热处理对ADC12铝合金导电性能的影响
Effects of Modification and Heat Treatment on Electrical Conductivity of ADC12 Aluminum Alloy
2016年36卷第11期页码：1201-1204
纸质出版日期： 2016 ，
DOI： 10.15980/j.tzzz.2016.11.023

扫描看全文

[1]王剑.变质工艺及热处理对ADC12铝合金导电性能的影响[J].特种铸造及有色合金,2016,36(11):1201-1204.

Wang Jian. Effects of Modification and Heat Treatment on Electrical Conductivity of ADC12 Aluminum Alloy[J]. Special Casting & Nonferrous Alloys, 2016,36(11):1201-1204.
[1]王剑.变质工艺及热处理对ADC12铝合金导电性能的影响[J].特种铸造及有色合金,2016,36(11):1201-1204. DOI： 10.15980/j.tzzz.2016.11.023.

Wang Jian. Effects of Modification and Heat Treatment on Electrical Conductivity of ADC12 Aluminum Alloy[J]. Special Casting & Nonferrous Alloys, 2016,36(11):1201-1204. DOI： 10.15980/j.tzzz.2016.11.023.

摘要

采用Sr、P及Sr+P复合变质的方法改变ADC12合金中Si相的形态与分布

研究其对合金电导率及硬度的影响

并通过T6热处理进一步提升合金的综合性能。结果表明

Sr变质对合金电导率的改善效果最为明显

电导率达到19.7MS/m

提升了约30%

Sr+P复合变质的效果次之

P变质的效果最差

不同变质工艺对合金硬度的影响并不明显。通过T6热处理可以明显提升合金的电导率及硬度

Sr变质合金的电导率及硬度（HBW）分别为22.3 MS/m及130。

Abstract

Effects of Sr

P and Sr+P modification as well as heat treatment on the primary Si phase morphology and distribution

electrical conductivity and hardness of ADC12 aluminum alloy were investigated in order to improve its electrical and mechanical properties

and comprehensive properties of the ADC12 alloy were improved further by T6 heat treatment.The results show that the electrical conductivity of alloy with Sr addition reaches 19.7MS/m

which is increased by approximately 30%comparaed with that of the unmodified alloy

and then Sr+P modified alloy

P modified alloy

while effect of modification on the hardness of the ADC12 alloy can be negligible.The electrical conductivity and hardness of aluminum alloy are largely improved by T6 heat treatment

where the electrical conductivity and hardness of the T6 treated alloy with Sr modification reach 22.3 MS/m and 130 HBW

respectively.