铝合金双台阶筒形件二次充液成形数值模拟

刘晓晶; 冯章超; 刘巍岩; 李官; 王雅为

doi:10.15980/j.tzzz.2016.10.006

实用研究 | 浏览量 : 0 下载量: 81 CSCD: 0

导出
分享
收藏
专辑

铝合金双台阶筒形件二次充液成形数值模拟
Numerical Simulation of Aluminum Alloy Double-stage Cylindrical Cup by Two-step Hydro-dynamical Deep Drawing
2016年36卷第10期页码：1031-1034
纸质出版日期： 2016 ，
DOI： 10.15980/j.tzzz.2016.10.006

扫描看全文

[1]刘晓晶,冯章超,刘巍岩,李官,王雅为.铝合金双台阶筒形件二次充液成形数值模拟[J].特种铸造及有色合金,2016,36(10):1031-1034.

Liu Xiaojing, Feng Zhangchao, Liu Weiyan, et al. Numerical Simulation of Aluminum Alloy Double-stage Cylindrical Cup by Two-step Hydro-dynamical Deep Drawing[J]. Special Casting & Nonferrous Alloys, 2016,36(10):1031-1034.
[1]刘晓晶,冯章超,刘巍岩,李官,王雅为.铝合金双台阶筒形件二次充液成形数值模拟[J].特种铸造及有色合金,2016,36(10):1031-1034. DOI： 10.15980/j.tzzz.2016.10.006.

Liu Xiaojing, Feng Zhangchao, Liu Weiyan, et al. Numerical Simulation of Aluminum Alloy Double-stage Cylindrical Cup by Two-step Hydro-dynamical Deep Drawing[J]. Special Casting & Nonferrous Alloys, 2016,36(10):1031-1034. DOI： 10.15980/j.tzzz.2016.10.006.

摘要

针对双台阶筒形件在一次充液拉深成形过程中悬空区减薄、起皱及破裂等问题

设计了二次充液拉深技术。采用Dynaform软件建立了有限元分析模型

分析了液室压力、模具参数对成形质量的影响

提出了优化的工艺参数。结果表明

提出的工艺方法可实现双台阶筒形件的精确成形

采用优化后的工艺参数可获得壁厚分布均匀

最小壁厚可达0.851mm的零件。

Abstract

In order to reduce the thinning

wrinkle and fracture of the double stepped cylindrical cup in the vacant areas which was shaped by one-step hydro-mechanical deep drawing

two-step hydro-mechanical deep drawing was introduced.The finite element model of hydromechanical deep drawing was established by the Dynaform software.The effects of process parameters such as forming pressure and mould parameters were analyzed by the finite element method in detail

and the optimized process parameters were presented.The results indicate that the proposed technological method is feasible for the integral forming of the double stepped cylindrical cup.Moreover

parts with uniform thickness distribution and high quality can be formed successfully by using the optimized parameters

and the final minimum wall thickness can be reached up to 0.851 mm.