压铸机头板设计的有限元分析

马建业; 黄志垣; 李培杰; 徐飞跃; 张百在; 郭光文

doi:10.15980/j.tzzz.2016.09.003

试验研究 | 浏览量 : 0 下载量: 60 CSCD: 1

导出
分享
收藏
专辑

压铸机头板设计的有限元分析
Finite Element Analysis of Head Board of Die Casting Machine
2016年36卷第9期页码：904-908
纸质出版日期： 2016 ，
DOI： 10.15980/j.tzzz.2016.09.003

扫描看全文

[1]马建业,黄志垣,李培杰,徐飞跃,张百在,郭光文.压铸机头板设计的有限元分析[J].特种铸造及有色合金,2016,36(09):904-908.

Ma Jianye, Huang Zhiyuan, Li Peijie, et al. Finite Element Analysis of Head Board of Die Casting Machine[J]. Special Casting & Nonferrous Alloys, 2016,36(9):904-908.
[1]马建业,黄志垣,李培杰,徐飞跃,张百在,郭光文.压铸机头板设计的有限元分析[J].特种铸造及有色合金,2016,36(09):904-908. DOI： 10.15980/j.tzzz.2016.09.003.

Ma Jianye, Huang Zhiyuan, Li Peijie, et al. Finite Element Analysis of Head Board of Die Casting Machine[J]. Special Casting & Nonferrous Alloys, 2016,36(9):904-908. DOI： 10.15980/j.tzzz.2016.09.003.

摘要

针对20 000kN压铸机头板的4种不同设计方案

采用UG对头板进行三维建模

并用ANSYS有限元分析对4种设计方案的头板进行检验。通过对4种方案的头板的有限元分析与强度、刚度校核对比

分析了压铸机头板中易出现应力集中且超过屈服强度极限的区域。

Abstract

Four design schemes of the head board for 20 000 kN die casting machine were modeled by UG software and simulated by the ANSYS software for the finite element analysis

stiffness verification and strength verification.Based on the results of the analysis and verification

the region of the head board was found

which was vulnerable to crack as the internal stress exceeded over the yield strength of the material.