Ti60合金热变形行为及微观组织

王克鲁; 鲁世强; 李鑫; 欧阳德来; 董显娟

doi:10.15980/j.tzzz.2016.05.008

实用研究 | 浏览量 : 0 下载量: 331 CSCD: 4

导出
分享
收藏
专辑

Ti60合金热变形行为及微观组织
Hot Deformation Behavior and Microstructure Evolution of Ti60 Alloy
2016年36卷第5期页码：473-476
纸质出版日期： 2016 ，
DOI： 10.15980/j.tzzz.2016.05.008

扫描看全文

[1]王克鲁,鲁世强,李鑫,欧阳德来,董显娟.Ti60合金热变形行为及微观组织[J].特种铸造及有色合金,2016,36(05):473-476.

Wang Kelu, Lu Shiqiang, Li Xin, et al. Hot Deformation Behavior and Microstructure Evolution of Ti60 Alloy[J]. Special Casting & Nonferrous Alloys, 2016,36(5):473-476.
[1]王克鲁,鲁世强,李鑫,欧阳德来,董显娟.Ti60合金热变形行为及微观组织[J].特种铸造及有色合金,2016,36(05):473-476. DOI： 10.15980/j.tzzz.2016.05.008.

Wang Kelu, Lu Shiqiang, Li Xin, et al. Hot Deformation Behavior and Microstructure Evolution of Ti60 Alloy[J]. Special Casting & Nonferrous Alloys, 2016,36(5):473-476. DOI： 10.15980/j.tzzz.2016.05.008.

摘要

在变形温度为920

100℃、应变速率为0.001

0.0s

-1

条件下对Ti60合金进行了等温恒应变速率压缩试验

分析了合金的流动行为和塑性变形机制。结果表明

Ti60合金的流动应力对变形温度和应变速率均较敏感。在α+β两相区

随变形温度的升高

α相体积分数逐渐减少

片状组织球化率增高;在变形温度较低、应变速率较高时

易发生局部流动现象。在β单相区

应变速率较低时

β相易发生动态再结晶;应变速率较高时

易造成机械失稳。

Abstract

Hot deformation behavior of Ti60 alloy was carried out on a Thermecmastor Zsimulator at920

100℃and strain rate at 0.001

0.0s

-1

.The elevated temperature deformation behavior of the Ti60 alloy was characterized based on ananalysis of the true stress-strain behavior.The results show that the low stress is increased with increasing in strain rate and decreasing in temperature.In theα+βtwo phase region

theαphase volume fraction is decreased and spheroidization rate of lamellar structure is increased with the increase of deformation temperature.The flow localization can be observed in the deformed microstructure with the lower deformation temperature and the higher strain rate.In theβphase region

the deformation mechanism is characterized by dynamic recrystallization when the strain rate is low

while the strain rate is high

it is easy to cause the mechanical instability.