粉末冶金制备Al<sub>2</sub>O<sub>3</sub>颗粒增强铜基复合材料的耐蚀性

柳秉毅; 陆文龙; 沈智荣; 杨楠; 缪倩倩; 冒冬鑫

doi:10.15980/j.tzzz.2016.02.024

复合材料 | 浏览量 : 0 下载量: 325 CSCD: 1

导出
分享
收藏
专辑

粉末冶金制备Al₂O₃颗粒增强铜基复合材料的耐蚀性
Corrosion Resistance of Al₂O₃/Cu Composites Prepared by Powder Metallurgy
2016年36卷第2期页码：204-207
纸质出版日期： 2016 ，
DOI： 10.15980/j.tzzz.2016.02.024

扫描看全文

[1]柳秉毅,陆文龙,沈智荣,杨楠,缪倩倩,冒冬鑫.粉末冶金制备Al_2O_3颗粒增强铜基复合材料的耐蚀性[J].特种铸造及有色合金,2016,36(02):204-207.

Liu Bingyi, Lu Wenlong, Shen Zhirong, et al. Corrosion Resistance of Al₂O₃/Cu Composites Prepared by Powder Metallurgy[J]. Special Casting & Nonferrous Alloys, 2016,36(2):204-207.
[1]柳秉毅,陆文龙,沈智荣,杨楠,缪倩倩,冒冬鑫.粉末冶金制备Al_2O_3颗粒增强铜基复合材料的耐蚀性[J].特种铸造及有色合金,2016,36(02):204-207. DOI： 10.15980/j.tzzz.2016.02.024.

Liu Bingyi, Lu Wenlong, Shen Zhirong, et al. Corrosion Resistance of Al₂O₃/Cu Composites Prepared by Powder Metallurgy[J]. Special Casting & Nonferrous Alloys, 2016,36(2):204-207. DOI： 10.15980/j.tzzz.2016.02.024.

摘要

采用机械合金化和粉末冶金法制备了Al

颗粒增强铜基复合材料

通过失重法对所制得的复合材料分别在不同的酸腐蚀条件下的腐蚀速率进行了测试

并采用扫描电镜对试样的腐蚀表面进行了观察。结果表明

/Cu复合材料的腐蚀速率随温度和腐蚀介质浓度的增加而显著增大

充分细化Al

颗粒和适当延长球磨时间有利于改善其耐蚀性能。

Abstract

particulate reinforced copper matrix composites were prepared by mechanical alloying combined with powder metallurgy technique.The corrosion rate of the composites was tested by mass loss under different acid corrosion solution

and the sample surface morphologies were observed by SEM.The results show that the corrosion rate of the composites prepared is increased obviously with increasing in the medium temperature and the acid concentration.The corrosion resistance can be improved by fully refining Al

particles and appropriately prolonging ball milling time.