异形坯连铸结晶器锥度的优化设计

黄文; 周建川; 申权; 杨拉道; 高琦

doi:10.15980/j.tzzz.2016.02.021

连续铸造 | 浏览量 : 0 下载量: 118 CSCD: 4

导出
分享
收藏
专辑

异形坯连铸结晶器锥度的优化设计
Optimal Design of Mould Taper in Continuous Casting Beam Blank
2016年36卷第2期页码：191-195
纸质出版日期： 2016 ，
DOI： 10.15980/j.tzzz.2016.02.021

扫描看全文

[1]黄文,周建川,申权,杨拉道,高琦.异形坯连铸结晶器锥度的优化设计[J].特种铸造及有色合金,2016,36(02):191-195.

Huang Wen, Zhou Jianchuan, Shen Quan, et al. Optimal Design of Mould Taper in Continuous Casting Beam Blank[J]. Special Casting & Nonferrous Alloys, 2016,36(2):191-195.
[1]黄文,周建川,申权,杨拉道,高琦.异形坯连铸结晶器锥度的优化设计[J].特种铸造及有色合金,2016,36(02):191-195. DOI： 10.15980/j.tzzz.2016.02.021.

Huang Wen, Zhou Jianchuan, Shen Quan, et al. Optimal Design of Mould Taper in Continuous Casting Beam Blank[J]. Special Casting & Nonferrous Alloys, 2016,36(2):191-195. DOI： 10.15980/j.tzzz.2016.02.021.

摘要

针对750mm×450mm×120mm异形坯

使用有限元软件建立了铸坯在结晶器内的传热、凝固、收缩及异形坯结晶器铜板热力耦合分析模型。在分析拉速对铸坯收缩、结晶器铜板温度及其变形的影响的基础上

确定了异形坯结晶器铜板的参考锥度

为异形坯结晶器的设计提供参考。

Abstract

Aiming at large beam blank with size of 750 mm × 450 mm × 120 mm

the ANSYS software was used to establish the heat transfer

solidification and shrinkage model in the mold of the beam blank and the thermo-mechanical coupling model of the mould copper plate.Influence of casting speed on the contraction of beam blank

temperature and deformation of the copper plate was analyzed to determine the reference taper of the copper plate

which provides a basis for the mould taper design of beam blank.