铸造Cu包覆石墨/Al复合材料干滑动磨损性能研究

商剑; 刘建

doi:10.15980/j.tzzz.2016.01.019

复合材料 | 浏览量 : 0 下载量: 87 CSCD: 0

导出
分享
收藏
专辑

铸造Cu包覆石墨/Al复合材料干滑动磨损性能研究
Dry Sliding Wear Behavior of Cast Aluminum Alloy/Graphite Composite with Cu Cladding
2016年36卷第1期页码：70-73
纸质出版日期： 2016 ，
DOI： 10.15980/j.tzzz.2016.01.019

扫描看全文

[1]商剑,刘建.铸造Cu包覆石墨/Al复合材料干滑动磨损性能研究[J].特种铸造及有色合金,2016,36(01):70-73.

Shang Jian, Liu Jian. Dry Sliding Wear Behavior of Cast Aluminum Alloy/Graphite Composite with Cu Cladding[J]. Special Casting & Nonferrous Alloys, 2016,36(1):70-73.
[1]商剑,刘建.铸造Cu包覆石墨/Al复合材料干滑动磨损性能研究[J].特种铸造及有色合金,2016,36(01):70-73. DOI： 10.15980/j.tzzz.2016.01.019.

Shang Jian, Liu Jian. Dry Sliding Wear Behavior of Cast Aluminum Alloy/Graphite Composite with Cu Cladding[J]. Special Casting & Nonferrous Alloys, 2016,36(1):70-73. DOI： 10.15980/j.tzzz.2016.01.019.

摘要

以ZL108铝合金为基体

添加Cu包覆石墨及稀土（Ce）

采用机械搅拌制备了Cu包覆石墨/Al复合材料。考察了不同Cu包覆石墨含量的Cu包覆石墨/Al复合材料的组织、硬度及磨损性能。结果表明

试验条件下

在2%

%的Cu包覆石墨的范围内

石墨分布趋于均匀。制备的Al-4Cu包覆石墨/Al复合材料具有较高的硬度及较好的耐磨性。添加石墨使复合材料的磨损机制由磨粒磨损转变为剥层磨损。

Abstract

The cast aluminum/graphite composites were prepared with Cu-coated graphite particles and rare element adding into the Al-Si alloy（ZL108）matrix through mechanical stirring method.The microstructure

hardness and wear behavior of the composites prepared with different Cu-coated graphite content were investigated.The results show that the dispersion of Cu-coated graphite is uniform when the Cu-coated graphite content is 2%

%.The cast aluminum/4% Cu-coated graphite exhibits a higher hardness and better wear resistance.The dominated wear mechanism is changed from abrasive wear for the cast aluminum 0% Cu-coated graphite to delaminated mechanism for cast aluminum 4% Cu-coated graphite composites.