铝合金压铸件浇口夹渣的分析及改善

压力铸造 | 浏览量 : 0 下载量: 108 CSCD: 1

扫描看全文

[1]杨诚,杨兴国,唐和雍,杨正平.铝合金压铸件浇口夹渣的分析及改善[J].特种铸造及有色合金,2015,35(11):1181-1183.

Yang Cheng, Yang Xingguo, Tang Heyong, et al. Analysis and Improvement of Slag Gate in Aluminum Alloy Die Castings[J]. Special Casting & Nonferrous Alloys, 2015,35(11):1181-1183.
[1]杨诚,杨兴国,唐和雍,杨正平.铝合金压铸件浇口夹渣的分析及改善[J].特种铸造及有色合金,2015,35(11):1181-1183. DOI： 10.15980/j.tzzz.2015.11.017.

Yang Cheng, Yang Xingguo, Tang Heyong, et al. Analysis and Improvement of Slag Gate in Aluminum Alloy Die Castings[J]. Special Casting & Nonferrous Alloys, 2015,35(11):1181-1183. DOI： 10.15980/j.tzzz.2015.11.017.

摩托车发动机铝合金曲轴箱体在压铸毛坯时常会出现浇口夹渣现象

而浇口夹渣又多为类似缩孔、油污和冷硬层3种形式。引起夹渣的原因主要是模具温度过高、冲头油过量和Al液含渣量高等。解决缩孔类夹渣

主要从降低模具温度入手;油污类夹渣

可采取调整冲头润滑油用量、加注位置及供给方式;应对冷硬层夹渣

主要靠调整压射延时和调整汤勺退回待机时间、过滤汤勺式样的导入、规范Al液除渣除气作业要求等措施。

The motorcycle engine crankcase is common produced by die casting aluminum alloy

and gate slag easily occurs in the die casting aluminum alloy crankcase.The gate slag is classed into three kinds of types:shrinkage cavity

oil

chilled layer.The main reasons are attributed to a higher mold temperature

excessive lubricant and high impurities in molten aluminum alloy.Through decreasing mold temperature

shrinkage cavity can be eliminated effectively.Aiming at oil slag

some measures

such as adjusting punch lubricant volume

adding location and supplying ways

were taken into account.For eliminating chilled layer slag

some ways are effective including modifying shoting time

staying time and strictly controlling degassing in the liquid aluminum alloy.

铝合金压铸浇口夹渣曲轴箱体

AluminumDie-CastingGate SlagCrankcase Housing

文章被引用时，请邮件提醒。

提交