挤压铸造Al-25Zn-10Si合金的组织与性能

张会

doi:10.15980/j.tzzz.2015.07.019

压力铸造 | 浏览量 : 0 下载量: 74 CSCD: 1

导出
分享
收藏
专辑

挤压铸造Al-25Zn-10Si合金的组织与性能
Microstructure and Properties of Extruding Casting Al-25Zn-10Si Alloy
2015年35卷第7期页码：734-736
纸质出版日期： 2015 ，
DOI： 10.15980/j.tzzz.2015.07.019

扫描看全文

[1]张会.挤压铸造Al-25Zn-10Si合金的组织与性能[J].特种铸造及有色合金,2015,35(07):734-736.

Zhang Hui. Microstructure and Properties of Extruding Casting Al-25Zn-10Si Alloy[J]. Special Casting & Nonferrous Alloys, 2015,35(7):734-736.
[1]张会.挤压铸造Al-25Zn-10Si合金的组织与性能[J].特种铸造及有色合金,2015,35(07):734-736. DOI： 10.15980/j.tzzz.2015.07.019.

Zhang Hui. Microstructure and Properties of Extruding Casting Al-25Zn-10Si Alloy[J]. Special Casting & Nonferrous Alloys, 2015,35(7):734-736. DOI： 10.15980/j.tzzz.2015.07.019.

摘要

在ZL102中加入纯Zn、纯Mg

得到Al-12.4Si-4.5Cu及Al-25Zn-10Si-5Mg合金

研究了挤压铸造成形合金的性能。结果表明

两组合金的最佳工艺方案相同

即模具预热温度为240℃

压力为150kN

保压时间为16s

浇注温度为630℃;挤压铸造件经过淬火时效处理之后

微观组织比未经热处理的微观组织均匀、细小

且硬度明显提高。加入5%的Mg元素后

合金组织性能优于不加Mg的。

Abstract

Al-12.4Si-4.5Cu and Al-25Zn-10Si-5Mg alloy were prepared by adding pure Zn and pure Mg into the ZL102 alloy.Properties of the two alloy prepared were analyzed by squeezing casting.The results reveal that the optimized processing parameters for the two alloy is the same including preheating mould at 240 ℃

pressure of 150 kN for 16 sand pouring at 630 ℃.After quenching and aging treatment

microstructure of the squeezing castings exhibits more homogeneous and finer compared with that of one without heat treatment.Meanwhile

hardness is increased significantly.With 5% Mg addition

the microstructure and properties of the alloy are superior to those of the initial alloy.