Mg-Gd-Y-Nd-Zr合金的时效热处理工艺优化

古东懂; 韩宝军; 何琼

doi:10.15980/j.tzzz.2015.06.027

轻有色合金 | 浏览量 : 0 下载量: 266 CSCD: 1

导出
分享
收藏
专辑

Mg-Gd-Y-Nd-Zr合金的时效热处理工艺优化
Optimization of Aging Heat Treatment Process of Mg-Gd-Y-Nd-Zr Alloy
2015年35卷第6期页码：659-662
纸质出版日期： 2015 ，
DOI： 10.15980/j.tzzz.2015.06.027

扫描看全文

[1]古东懂,韩宝军,何琼.Mg-Gd-Y-Nd-Zr合金的时效热处理工艺优化[J].特种铸造及有色合金,2015,35(06):659-662.

Gu Dongdong, Han Baojun, He Qiong. Optimization of Aging Heat Treatment Process of Mg-Gd-Y-Nd-Zr Alloy[J]. Special Casting & Nonferrous Alloys, 2015,35(6):659-662.
[1]古东懂,韩宝军,何琼.Mg-Gd-Y-Nd-Zr合金的时效热处理工艺优化[J].特种铸造及有色合金,2015,35(06):659-662. DOI： 10.15980/j.tzzz.2015.06.027.

Gu Dongdong, Han Baojun, He Qiong. Optimization of Aging Heat Treatment Process of Mg-Gd-Y-Nd-Zr Alloy[J]. Special Casting & Nonferrous Alloys, 2015,35(6):659-662. DOI： 10.15980/j.tzzz.2015.06.027.

摘要

采用金相显微镜、扫描电镜、能谱仪以及维氏硬度计等

研究了时效热处理工艺对Mg-Gd-Y-Nd-Zr合金的组织和性能的影响。结果表明

时效热处理能够明显改善Mg-Gd-Y-Nd-Zr镁合金的组织和力学性能

时效时合金晶粒内部析出细小弥散的化合物

随着时效温度升高

硬度升高

但是时效温度过高或时间过长会出现过时效现象

导致硬度降低。固溶处理后的最佳时效热处理工艺为200℃×16h

合金的硬度值（HV）达到73.38。

Abstract

Influences of aging treatment process on microstructure and mechanical properties of Mg-Gd-YNd-Zr alloy were investigated by optical microscopy（OM）

scanning electron microscopy（SEM）

spectrometer and hardness tester.The results show that aging treatment can obviously improve the microstructure and mechanical properties of Mg-Gd-Y-Nd-Zr alloy.Intermetallic compounds are precipitated homogeneously along grains

and the hardness is increased with increasing in aging temperature.However

if the aging temperature is too high or time too long

it can lead to over aging phenomenon

resulting in decrease of hardness of the alloy.The desirable aging heat treatment process is 200 ℃×16hafter solid solution treatment

where hardness value of the alloy reaches 73.38（HV）.