一种典型薄壁异形铝合金铸件的研制

潘俊杰; 洪润洲; 李大奎; 杜旭初; 罗传彪; 樊振中

doi:10.15980/j.tzzz.2015.06.012

精密铸造 | 浏览量 : 0 下载量: 128 CSCD: 2

导出
分享
收藏
专辑

一种典型薄壁异形铝合金铸件的研制
Manufacture of a Typical Thin-walled Shaped Aluminium Alloy Casting
2015年35卷第6期页码：605-607
纸质出版日期： 2015 ，
DOI： 10.15980/j.tzzz.2015.06.012

扫描看全文

[1]潘俊杰,洪润洲,李大奎,杜旭初,罗传彪,樊振中.一种典型薄壁异形铝合金铸件的研制[J].特种铸造及有色合金,2015,35(06):605-607.

Pan Junjie, Hong Runzhou, Li Dakui, et al. Manufacture of a Typical Thin-walled Shaped Aluminium Alloy Casting[J]. Special Casting & Nonferrous Alloys, 2015,35(6):605-607.
[1]潘俊杰,洪润洲,李大奎,杜旭初,罗传彪,樊振中.一种典型薄壁异形铝合金铸件的研制[J].特种铸造及有色合金,2015,35(06):605-607. DOI： 10.15980/j.tzzz.2015.06.012.

Pan Junjie, Hong Runzhou, Li Dakui, et al. Manufacture of a Typical Thin-walled Shaped Aluminium Alloy Casting[J]. Special Casting & Nonferrous Alloys, 2015,35(6):605-607. DOI： 10.15980/j.tzzz.2015.06.012.

摘要

某典型薄壁异形铸件采用ZL101A合金生产

基于支架铸件结构形状与铸造工艺难点

试验设计了熔模+低压铸造复合凝固成形工艺。结果表明

通过在铸件蜡模薄壁区域增设加强筋与排气条、调整型壳焙烧阶梯升温工艺参数、优化低压充型及T6固溶淬火热处理参数

结合淬火校正工装与机加工校准设计

有效解决了薄壁异形支架铸件的浇不足、缩松等冶金缺陷

研制出了合格的铸件。

Abstract

A typical thin-walled complex component was produced with ZL101 Acasting alloy.Based on the structure shape and casting difficulties analysis of the bracket casting

composite solidification process of investment shell mold combined with low-pressure casting was designed.The results reveal that by adding reinforcing rib and exhausting slot within wax pattern

adjusting step heating process parameters of investment shell mold

optimizing the technological parameters of low-pressure casting and the T6heat-treatment

combining with the design of quenching deformation revise and manufacturing benchmark

misrun and shrinkage porosities defects in the bracket casting could be eliminated successfully

obtaining the qualified bracket.