铸造工艺仿真设计后处理和工艺改进应用技术

杨光耀; 王仲珏; 朱协彬; 房文亮

doi:10.15980/j.tzzz.2014.11.007

计算机应用技术 | 浏览量 : 0 下载量: 71 CSCD: 1

导出
分享
收藏
专辑

铸造工艺仿真设计后处理和工艺改进应用技术
Applied Technology on Postprocessing and Process Improvement of Simulation Design of Casting Process
2014年34卷第11期页码：1143-1146
纸质出版日期： 2014 ，
DOI： 10.15980/j.tzzz.2014.11.007

扫描看全文

[1]杨光耀,王仲珏,朱协彬,房文亮.铸造工艺仿真设计后处理和工艺改进应用技术[J].特种铸造及有色合金,2014,34(11):1143-1146.

Yang Guangyao, Wang Zhongjue, Zhu Xiebin, et al. Applied Technology on Postprocessing and Process Improvement of Simulation Design of Casting Process[J]. Special Casting & Nonferrous Alloys, 2014,34(11):1143-1146.
[1]杨光耀,王仲珏,朱协彬,房文亮.铸造工艺仿真设计后处理和工艺改进应用技术[J].特种铸造及有色合金,2014,34(11):1143-1146. DOI： 10.15980/j.tzzz.2014.11.007.

Yang Guangyao, Wang Zhongjue, Zhu Xiebin, et al. Applied Technology on Postprocessing and Process Improvement of Simulation Design of Casting Process[J]. Special Casting & Nonferrous Alloys, 2014,34(11):1143-1146. DOI： 10.15980/j.tzzz.2014.11.007.

摘要

主要以应用MAGMA soft和华铸CAE两款软件为例

针对铸造工艺仿真设计后处理和工艺改进的主要内容与使用方法进行了较为详细的归纳、分析和总结。以实例应用验证其内容和方法的正确性并对不良工艺提出解决办法。最终

通过铸造工艺仿真应用技术获得合格工艺、优化工艺和生产条件下最佳工艺的内容和方法。

Abstract

The main contents and using methods of postprocessing and process improvement of simulation design of casting process for the example of applying MAGMA soft and InteCAST were analyzed comparatively.A example was used to verify the correctness about contents and methods

and the solutions for bad process were presented.Eventually

through the available technology of casting process simulation design for obtaining qualified process

optimization process and content

method of optimum processes under production was visualized.