铝合金不粘锅压铸模浇注系统设计及充型模拟

压力铸造 | 浏览量 : 0 下载量: 185 CSCD: 1

铝合金不粘锅压铸模浇注系统设计及充型模拟
Design and Filling Simulation of Gating System for Die Casting Die of Aluminum Alloy Cookware based on the Flow-3D
2012年32卷第7期页码：624-627
纸质出版日期： 2012 ，
DOI： 10.15980/j.tzzz.2012.07.005

扫描看全文

[1]韩雄伟,李欣星,冷真龙,胡兆国.铝合金不粘锅压铸模浇注系统设计及充型模拟[J].特种铸造及有色合金,2012,32(07):624-627.

Han Xiongwei, Li Xinxing, Leng Zhenlong, et al. Design and Filling Simulation of Gating System for Die Casting Die of Aluminum Alloy Cookware based on the Flow-3D[J]. Special Casting & Nonferrous Alloys, 2012,32(7):624-627.
[1]韩雄伟,李欣星,冷真龙,胡兆国.铝合金不粘锅压铸模浇注系统设计及充型模拟[J].特种铸造及有色合金,2012,32(07):624-627. DOI： 10.15980/j.tzzz.2012.07.005.

Han Xiongwei, Li Xinxing, Leng Zhenlong, et al. Design and Filling Simulation of Gating System for Die Casting Die of Aluminum Alloy Cookware based on the Flow-3D[J]. Special Casting & Nonferrous Alloys, 2012,32(7):624-627. DOI： 10.15980/j.tzzz.2012.07.005.

铝合金压铸不粘锅在实际生产中很容易出现各种缺陷

而且不粘锅在喷涂过程中要经过430℃的高温烘烤

很容易在铸件表面出现气泡

从而导致产品报废。针对这一问题

对铝合金压铸不粘汤锅进行了浇注系统的设计计算。利用数值模拟软件Flow-3D

针对设计方案进行了充型模拟

分析了模拟结果并根据结果重新设计了浇道。新设计的浇道能够实现顺序充填

充填效果较好

产生缺陷的可能性降低。

Aluminum die-casting non-stick pan exists variety of defects in the actual production

and bubble easily occurs in its surface due to be subjected baking at 430℃ during spraying process

resulting in product failure.Aiming at the problems

gating system of the aluminum die casting non-stick pot was designed and calculated

and the filling process of the designed scheme was simulated by the Flow-3D software.Based on the simulated result

the gating system was modified.Smooth filling can be observed in the modified gating system with the desirable filling effects

improving greatly the product quality and decreasing the defects.

铝合金不粘锅压铸充型模拟FLOW-3D

Aluminum AlloyNon-Stick PanDie CastingFilling SimulationFLOW-3D

文章被引用时，请邮件提醒。

提交