ETC节流阀体压铸件的模具改进及效果评价

袁静; 戴维

doi:10.15980/j.tzzz.2012.06.021

压力铸造 | 浏览量 : 0 下载量: 24 CSCD: 2

导出
分享
收藏
专辑

ETC节流阀体压铸件的模具改进及效果评价
Mould Modification of ETC Throttle Valve Body and its Evaluation
2012年32卷第6期页码：541-543
纸质出版日期： 2012 ，
DOI： 10.15980/j.tzzz.2012.06.021

扫描看全文

[1]袁静,戴维.ETC节流阀体压铸件的模具改进及效果评价[J].特种铸造及有色合金,2012,32(06):541-543.

Yuan Jing, Dai Wei. Mould Modification of ETC Throttle Valve Body and its Evaluation[J]. Special Casting & Nonferrous Alloys, 2012,32(6):541-543.
[1]袁静,戴维.ETC节流阀体压铸件的模具改进及效果评价[J].特种铸造及有色合金,2012,32(06):541-543. DOI： 10.15980/j.tzzz.2012.06.021.

Yuan Jing, Dai Wei. Mould Modification of ETC Throttle Valve Body and its Evaluation[J]. Special Casting & Nonferrous Alloys, 2012,32(6):541-543. DOI： 10.15980/j.tzzz.2012.06.021.

摘要

介绍了ETC节流阀体产品结构、模具结构及生产过程中出现的废品情况

对模具的进料系统及排溢系统作了分析改进

将压室由50mm调整为60mm

降低了压射比压。并对生产过程中的实际工艺参数进行了测量

发现实际的压射速度远低于原设计值

重新对压射速度进行了调整

从而达到了减少铸件废品的目的。

Abstract

Structure of ETC throttle valve body

mould structure and scrap occurred in the production were introduced.The feeding system and exhausting system were modified.The injection pressure was decreased by enlarging chamber from 50 mm to 60 mm in diameter.Practical running parameters were measured.It is found that the real injection velocity is lower far away designed parameters.Through adjusting injection velocity

the scrap was decreased.

关键词

辅助浇道溢流排气系统工艺参数测量

Keywords

Assisted Pouring ChannelExhausting SystemProcessing Parameters Measurement

references

文章被引用时，请邮件提醒。

提交

北美地区双腔节流阀体压铸不良品分析及对策