硅溶胶涂料复合制壳工艺的研究

周子成; 刘耀华; 傅朝荣; 孙勤; 柳贤福

浏览量 : 0 下载量: 63 CSCD: 0

导出
分享
收藏
专辑

硅溶胶涂料复合制壳工艺的研究
Study on the Process of Shell Moulding with Composite Coating—Colloidal Silica
1989年第6期页码：17-21
纸质出版日期： 1989 ，
DOI：

扫描看全文

[1]周子成,刘耀华,傅朝荣,孙勤,柳贤福.硅溶胶涂料复合制壳工艺的研究[J].特种铸造及有色合金,1989(06):17-21.

Zhou Zicheng, Liu Yaohua, Fu Chaorong. Study on the Process of Shell Moulding with Composite Coating—Colloidal Silica[J]. Special Casting & Nonferrous Alloys, 1989,(6):17-21.
[1]周子成,刘耀华,傅朝荣,孙勤,柳贤福.硅溶胶涂料复合制壳工艺的研究[J].特种铸造及有色合金,1989(06):17-21. DOI：

Zhou Zicheng, Liu Yaohua, Fu Chaorong. Study on the Process of Shell Moulding with Composite Coating—Colloidal Silica[J]. Special Casting & Nonferrous Alloys, 1989,(6):17-21. DOI：

摘要

本文论述了硅溶胶涂料复合制壳工艺

研究了远红外热风联合干燥过程的物理化学变化

研制了几种复合界面强化液等等。生产实践表明

该工艺生产的精铸件表面粗糙度和尺寸精度比水玻璃型壳提高1～2级

生产成本比硅酸乙酯（30）型壳节约3900元/吨。

Abstract

The process of shell moulding with composite coatings of colloidal silica and sodium silicate is discussed in this paper. The physi-cochemical change during combined drying by far infraredhet blast is investigated. Several strengthening solutions for interface of the composite are developed.Practical experience shows that the process can improve the casting surface roughness and size precision 1-2 grade compared with process of the shell moulding with sodium silicate

and can reduce the production cost of castings 3900 yuan per ton comparad with process of the shell moulding with ethyl silicate （30） .