离心铸球工艺研究

乔凤岐; 曹浩林

浏览量 : 0 下载量: 57 CSCD: 10

导出
分享
收藏
专辑

离心铸球工艺研究
Study on Technic Process of Grinding Ball by Centrifugal Casting
1998年第2期
纸质出版日期： 1998 ，
DOI：

扫描看全文

[1]乔凤岐,曹浩林.离心铸球工艺研究[J].特种铸造及有色合金,1998(02):22-25.

Qiao Fengqi Cao Haolin. Study on Technic Process of Grinding Ball by Centrifugal Casting[J]. Special Casting & Nonferrous Alloys, 1998,(2).
[1]乔凤岐,曹浩林.离心铸球工艺研究[J].特种铸造及有色合金,1998(02):22-25. DOI：

Qiao Fengqi Cao Haolin. Study on Technic Process of Grinding Ball by Centrifugal Casting[J]. Special Casting & Nonferrous Alloys, 1998,(2). DOI：

摘要

介绍了离心铸造磨球的工艺，以及转速、内浇口断面积计算方法和影响工艺过程的因素。在离心铸球工艺中，可应用有效重度和等效压头原理计算转速和内浇口断面积。转速在５００～７００ｒ／ｍｉｎ和每个内浇口面积不小于０．４ｃｍ２时，铸球内部晶粒度达到６～７级，硬度值分布均匀。同时分析了在旋转的浇注系统中，金属液运动的规律。

Abstract

The technology of grinding ball by centrifugal casting

the rotational speed

the method for calculation of ingate area and factors influencing technological process were introduced. It is suggested to apply the principle of effective gravity and equivalent pressure head to calculate the rotational speed and ingate area in the processing of grinding ball by centrifugal casting. The grain size in the ball attained up to 6-7 degree and the hardness was uniformly distributed

when the rotational speed within the range 500-700 r/min and each ingate area is not as low as 0.4 cm 2. The moltion law of molten metal in the rotational gate was analysed.