提高陶瓷型铸造铸铁浮封环合格率的研究

颜银标; 钱治中

浏览量 : 0 下载量: 37 CSCD: 0

导出
分享
收藏
专辑

提高陶瓷型铸造铸铁浮封环合格率的研究
Elevation of the Yield of Floating Sealing Rings with Cast Iron in Ceramic Mold Casting
2001年第3期页码：30-31
纸质出版日期： 2001 ，
DOI：

扫描看全文

[1]颜银标,钱治中.提高陶瓷型铸造铸铁浮封环合格率的研究[J].特种铸造及有色合金,2001(03):30-31+1.

Yan Yinbiao. Elevation of the Yield of Floating Sealing Rings with Cast Iron in Ceramic Mold Casting[J]. Special Casting & Nonferrous Alloys, 2001,(3):30-31.
[1]颜银标,钱治中.提高陶瓷型铸造铸铁浮封环合格率的研究[J].特种铸造及有色合金,2001(03):30-31+1. DOI：

Yan Yinbiao. Elevation of the Yield of Floating Sealing Rings with Cast Iron in Ceramic Mold Casting[J]. Special Casting & Nonferrous Alloys, 2001,(3):30-31. DOI：

摘要

某单位用陶瓷型精铸生产的高铬钼白口铸铁浮封环废品率一直在 45 %左右

通过统计数据分析和金相组织观察

发现废品成因有二 :一是铁水成分偏离共晶点 ;二是热态整形校圆。采取控制铁水成分、取消热校圆和调整生产工序等措施后

浮封环总废品率下降到 10 %以下

取得了良好的技术经济效益

Abstract

The scrap ratio of floating sealing rings with high CrMo white cast iron was about 45% in ceramic mold. The reason of scrap formation was attributed to the composition far from eutectic point and heating calibration circle through statistic analysis and metallographic observation. The total scrap ratio of floating sealing ring decreased below 10% through controlling the iron melt composition

canceling heating calibration circle and adjusting production procedure so as to obtain the good technic economic benefits.

关键词

高铬钼合金铸铁浮封环共晶点热整形

Keywords

High CrMo Alloy Cast IronFloating Sealing RingEutectic PointHeating Calibration Circle

references

文章被引用时，请邮件提醒。

提交

暂无数据